User's Manual
BMP44 - User manual012
Settings screen
The settings menu for BMP40 can be loaded by pressing the rotary selection dial.
Output gain:
The gain can be adjusted within a range of +8 dB and -82 dB,
allowing optimization of the output level according to the input
sensitivity of the connected amplier or pre-amplier. For adjusting
the output gain, rotate the function dial until ‘Gain’ is highlighted
and press it for proceeding to the gain settings. The level can be
adjusted by rotating clockwise (tuning up) or counter-clockwise
(tuning down). Press the rotary dial for conrming the currently set
output level.
Output gain
0dB
Connected
Paired
Info
Factory reset
BMP40 SETTINGS
Connected:
Information about the connected transmitting device is shown when highlighted ‘Connected’. This menu includes the device
name and Mac address. Press the rotary selection dial twice for disconnecting the currently connected device.
Paired:
8 device ID’s of recently paired transmitters are stored as authorized devices and shown in this list. These authorized devices
are allowed for direct pairing with the BMP40 without making it discoverable. (without pressing the button in the main
module screen)
Devices can be removed from this list by pressing the rotary dial when highlighted ‘Paired’, allowing browsing through the list.
Select the device and press the rotary dial again to remove it from the pairing list. (Select OK to remove, or cancel to keep it)
Info:
Gives an overview of the BMP40 Mac address and running software versions.
Factory reset:
Factory reset will recall all settings to factory defaults and all previously made settings and congurations will be lost. After
selecting factory reset, a conrmation will be asked whether all settings denitely need to be reset to factory defaults. When
conrmed, all settings will be lost.
Back:
Returning to the player mode screen is done by selecting ‘Back’.