User's Manual

BMP44 - User manual 013
Step 1:
Make sure that the slot whereto the module should be installed is open and ready for installation. Depending of the main unit,
some module slots will be covered by blind panels when delivered. The corresponding blind panels should be removed by
releasing the screws on both ends.
Step 2:
Before removing the modules from their protective bag, we recommend touching a grounded metal chassis (or any other
grounded point) to prevent electrostatic discharges affecting the sensitive electronic components. It is recommended to always
hold the module card by the metal connection panel and avoid touching of the components on the circuit board directly.
Step 3:
Align both edges of the module with the guide rails inside the slot and carefully insert the module into the slot. It should slide
into the slot without any considerable resistance when well positioned into the guide rail.
Chapter 4
Installing the BMP40
CAUTION
Before installing the BMP40 to any SourceCon™ compatible device, make sure the power is switched off.
Malfunctions or electrical shocks may occur otherwise.