Use and Care Manual

PWS -Premier Canopies 1-888-547-8797 Page 17

Stitcher

Screws

Sinker Screws

Screw Pattern - End Gables

(g 10)

Rake Trim

Step 1 - Locate the le side, uncut Rake trim, and position it

as shown in (photo 30). If the roof sheet was fastened in the

correct location, the top edge should line up directly in the

middle of the peak, and the bottom edge should line up with

the roof sheet. If it does not align properly, the only solution

would be to move the roof, if the rake trim is too short, or cut

the top of the rake trim if it’s too long.

Step 2 - Before fastening the rake trim to the roof sheet and

end gable, check to make sure the trim’s shape is square itself

and square to the sheet. is can be done several ways, one

method is to use a framing square. Another way is to use a

level, (photo 31). However, the accuracy of this method is

directly related to how level the ground is that the canopy is

built upon.

(photo 30)

(photo 31)

Rake trim