Data Sheet

30
Version 1.0
IMPORTANT NOTE: In the event that these conditions cannot be met (for example certain laptop congurations
or co–location with another transmitter), then the FCC authorization is no longer considered valid and the FCC
ID cannot be used on the nal product. In these circumstances, the OEM integrator will be responsible for re–
evaluating the end product (including the transmitter) and obtaining a separate FCC authorization.
24.2.3 ProductLabelling
This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm
may be maintained between the antenna and users. The final end product must be labelled in a visible area with
the following: “Contains FCC ID: 2AJMTLOPY4R”and “Contains IC: 22263-LOPY4R”. The grantee’s FCC ID and IC
can be used only when all FCC and ISED compliance requirements are met.
24.2.4 ManualInformationtotheUser
The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove
this RF module in the user’s manual of the end product which integrates this module.
In the user manual of the end product, the end user has to beinformed that the equipment complies with FCC radio–
frequency exposure guidelines set forth for an uncontrolled environment.
The end user has to also be informed that any changes or modications not expressly approved by the
manufacturer could void the user’s authority to operate this equipment.
The end user manual shall include all required regulatory information/warning as show in this manual.
The maximum operating ambient temperature of the equipment declared by the manufacturer is –40~+85C
Receiver category 3
25.0 RevisionHistory
Table 24 – Document revision history
Vers
ion
1.0 InitialRelease
ISED RSS Warning:
This device complies with Innovation, Science and Economic Development Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'ISED applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
ISED RF exposure statement:
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance 20cm between the radiator& your body.This transmitter must not
be co-located or operating in conjunction with any other antenna or transmitter. Le rayonnement de la classe b repecte
ISED fixaient un environnement non
contrôlés.Installation et mise en
œuvre de ce matériel devrait avec échangeur distance minimale entre 20 cm ton corps.Lanceurs ou ne peuvent pas
coexister cette antenne ou capteurs avec d’autres.