INTRODUCTION The newest technological are integrated in our Two Way Alarm and Remote Engine Start alarm system. They are fully programmable for your customers to have personalized security and comfort. The ultimate in comfort and protection. ALARM The alarm integrated in the system is a fully programmable unit with multi zone protection such as shock sensor, starter kill output, control power locks and much more.
WIRING DESCRITION 10PIN CONNECTION FEATURES AND OPERATIONS IGNITION LOCK: Door locks automatically when ignition is ON and brake pedal is depressed after driving 15 BROWN Parking light wire (12v positive output) connect to parking light wire BROWN Parking light wire (12v positive output) connect to parking light wire PURPLE TACH wire (AC input) connect to TACH signal wire (coil or injector) YELLOW/ GREEN Starter kill wire (500mA negative output) connect to starter kill relay.
FEATURES AND OPERATIONS WIRING DESCRITION 4 PIN CONNECTION ARMING: Arming the system will also enable the starter kill and unlock the door, if installed. WHITE Switched ignition input (12v positive input) connect to ignition wire. GREEN Hand brake wire (negative input) connect to switched side of hand brake switch. PASSIVE ARMING: The system will automatically arm without door lock itself 30 seconds after the ignition has been turned OFF and the last door closed.
TRANSMITTER CODE LEARNING WIRE CONNECTION GUIDE Learning button Blue Battery Starter Accessories Ignition STEP1 DELETE CODE FOR CONTROL UNIT: Press learning button at control unit until the LED at control unit (near the learning button) turn off. System will delete all transmitter code.
DOOR LOCK WIRING DIAGRAM TRANSMITTER OPERATION FUNCTION BUTTON ACTIVATION Press once Press press then while driving. System armed and doors locked without chirp System enter anti car-hijacking mode. ENGINE START ENGINE START NC COM NO ARM SILENTLY ARMING NO CHIRP ANTI CARHIJACKING BUTTON PRESSING BUTTON Press once and press again within 5 seconds. NC COM NO COM NO NC BUTTON Orange/black white/black (-) Actuator +12V (-) NO Press once +12V To select vibration on or off.
PROGRAMING IMPORTANT: The installation must be complete before accessing programming mode. DOOR LOCK PULSE: Some European Vehicles such as Mercedes-Benz and Audi, require longer lock and unlock pulse to operate the vacuum pump. Start the engine, press button and at the same time. Parking light will turn on 0.5 second, that means 0.5 second door lock pulse selects. If the parking light turn on 4 seconds, that means 4 seconds door lock pulse selects.
COMMOM BUTTON USED BY 3508 TRANSMITTER ANTENNA INSTALLATION POINTS ARM & LOCK THE DOORS DISARM & UNLOCK THE DOORS ARM & LOCK THE DOOR SIRENTLY ENGINE START 5-10cm Antenna frequency 5-10cm head location Mainframe VIBRATION ON/OFF TROUBLESHOOTING TRANSMITTER OPERATION ADJUST REALTIME CLOCK: Keep press button 8 seconds until the display show the hour flashing. Use button to adjust hour and use button to adjust minute. When it is done, press button to exit.
TWO WAY LCD TRANSMITTER OPERATION TRANSMITTER OPERATION Two Way Transmitter 2 1 3 4 5 6 7 8 9 10 11 12 13 14 15 16 1. RF transmit / Receive 2. Silent mode 3. Vibration mode 4. AM 5. PM 6. Lock 7. Impact detector alarm 8. Unlock 9. Parking light 10. Door open 11. Time display 12. Successful learning indicator 13. Engine start 14. Low battery indicator 15. Trunk release 16.
WIRING DESCRITION The newest technological are integrated in our Two Way Alarm and Remote Engine Start alarm system. They are fully programmable for your customers to have personalized security and comfort. The ultimate in comfort and protection. ALARM The alarm integrated in the system is a fully programmable unit with multi zone protection such as shock sensor, starter kill output, control power locks and much more.
