PDA User Manual

Chapter 5: Configuration
Advanced Interface And Network
130 Ikôn Rugged PDA (Windows CE 5.0) User Manual
This utility allows you to ‘tweak’ or adjust Advanced system settings (interface, network
and servers), User settings (font size and docking port message), and provides a
Registry Editor.
5.8.1 Advanced Interface And Network
AP Density
This option allows you to determine the signal strength at which the Ikon radio will begin
searching for a new Access Point (AP): High, Medium or Low. If, for example, this option is
set to High, the radio will begin searching for a new Access Point while still at a fairly strong
signal strength. Setting AP Density to Low will cause the radio to wait until the signal
strength is significantly low before attempting to connect to another Access Point.
Depending on your site configuration—for example, the shelving, the Access Point cover-
age, etc.—a higher setting may improve through-put, increase and maintain signal strength,
and reduce missed transmissions.
Enable IPv6
This option allows you to enabled Internet Protocol specification, version 6, that has been
published to use 128-bit IP address (replacing version 4).