PDA User Manual

Chapter 6: Peripheral Devices & Accessories
Wiring Vehicle Power To The Cradle
240 Ikôn Rugged PDA (Windows CE 5.0) User Manual
6.10.3.1 Wiring Vehicle Power To The Cradle
The Powered Vehicle Cradle uses the automotive power outlet or the vehicle fuse box to
power from the vehicle battery system. The CLA power cable (PN 1081141) is used for the
automotive power outlet; the Power Extension cable (PN 1081142) is used for the vehicle
fuse box.
Figure 6.14 CLA Power Cable
Power cables are equipped with fuses and instructions are supplied with each cable. Use
only a 4A slow blow Safety-approved fuse in the fuse assembly.
These cables should only supply operating power from the vehicle to the Powered Vehicle
Cradle from 12VDC or 24VDC systems.
• The Powered Vehicle Cradle draws no more than 1.9A @ 12VDC or 0.95A @ 24VDC.
Any additional wiring, connectors or disconnects used should be rated for at least 4A.
The Powered Vehicle Cradle and peripherals can be used with both negative ground
systems when using the Power Extension cable. Peripheral wiring should be closely
examined to avoid ground loops in positive ground systems.
• There is the option of connecting power to the cradle before or after the ‘key’ switch.
Warning: Applying a voltage above 36VDC or reversing polarity may result in perma-
nent damage to the vehicle cradle power section and will void the product
warranty. For safety reasons, disconnect the vehicle cradle power cable
when the vehicle battery is being charged by an source other than the
vehicle alternator.
DC Power Plug
Automotive Power
Adaptor Plug