Specifications
Read
these instructions
and
the
following precautions carefully.
What is included in the box
In
addition
to
this manual, the box contains:
•
7-band
graphic equalizer
•
Warranty
card
• 2
mounting
brackets •
User
manu
• 8 Phillips-head screws
Before starting
Mounting
precautions
This Equlizer can
be
mounted next to the source unit or under the dash using the
mounting brackets. The front panel controls should be easily accessible from the
driver's seat.
In
addition:
• This unit requires additional mobile audio components for proper operation.
• Always
use
great care when attaching anything
to
a vehicle! Check clearances
in
front
of,
behind,
and
on
both sides of the planned installation before drilling any
holes or installing any screws.
Wiring precautions
Disconnect the ground
(-)
terminal
on
the vehicle's battery.
WARNING!
To prevent
short
circuits during installation, always discon-
nect
the vehicle's negative (-) battery lead before making
any
connections.
• This unit
is
exclusively for vehicles with a negative ground, 12V battery system.
• A good chassis ground connection
is
critical
to
minimize resistance and avoid noise
problems.
Use
the shortest wire possible
and
securely connect it
to
the car chassis
and
the source unit ground.
•
When
routing
RCA
cables, keep the cables away
from
the power cables and output
speaker wires.
• If
you
are using a source unit without a remote turn-on lead, the this unit
can
be
turned
on
with a switched accessory lead. This accessory power source
is
located
in
the factory harness
at
the back of the radio. This lead turns
on
and off with the
ignition
key.
•
Do
not open the case. There are
no
user-serviceable parts inside. If
you
require
assistance, consult your dealer or
an
authorized dealer service center.
6