PLD175TBT WWW. PYLEAUDIO.
CONTENTS Safety Information 1 Installation 1. DIN FRONT-MOUNT (Method A) 2 2.
Safety Information CAUTION: Automotive DVD player is a class 1 laser product. However this car DVD player uses a visible/invisible laser beam which could cause hazardous radiation exposure if directed. Be sure to operate the car DVD player correctly as instructed. Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. Do not open covers and do not repair yourself. Refer servicing to qualified personnel.
Installation Label side up Do not touch the underside of the disc Do not bend Wipe the disc from center toward the outside edge Preparing New Discs with Rough Spots A new disc may have rough edges on its inside and outside edges. If a disc with rough edges is used, the proper setting will not be performed and the player will not play the disc. Therefore, remove the rough edges in advance by using a ballpoint pen or pencil as shown on the below.
1 2 182 53 3 (Fig.1) 1. Dashboard 2. Hoder After inserting the holder into the dashboard, select the appropriate tab according to the thickness of the dashboard material and ben them inwards to secure the holder in place. 3. Screw 1. Frame 2. Release Frame Key Insert the release frame key into the groove at the right side of the frame, then prize out to remove the frame (You can also use the key to remove the frame from the left side.) 3.
Wiring Diagram Red to Front Rch RCA output White to Front Lch RCA output ANTENNA Socket TV Socket Yellow to Video output 1 Yellow to Video output 2 Bluetooth Antenna White to Rear Lch RCA output Red to Rear Rch RCA output Green to SUB-Woofer output Violet Rear Right + Yellow to Battery B+ Violet/Black Rear Right - Black to GND B- Grey Front Right + Red to ACC Grey/Black Front Right - Blue to ANT White Front Left + Green Rear Left + White/Black Front Left - Green/Black Rear Left - 4
Operation Location and Function of Keys 2 42 6 14 17 7 44 9 13 20 43 8 24 22 16 23 21 25 12 11 15 AV IN To connect with mobile audio or video system by the cable (included in unit) When you press 41 button (3) and the front panel flip down : 5 4 10 5 1 18 3 19 43 26
Remote control: 2 7 MUTE 27 A-B DISP MODE RPT SUB-T - Do not put in a trouser pocket. - Keep away from food, moisture and dirt. - Do not place in direct sunshine. 13 AUDIO 28 ZOOM 42 40 ANGLE ENTER 29 30 31 39 38 22 VOL 6 Battery replacement Battery type: a button cell lithium battery (CR2025 3V) 1. Remove the battery holder by pressing the locking tab with your thumb and pulling it out.
Using The Detachable Front Panel General Operation REMOVING AND PROTECTING DETACHABLE FRONT PANEL. The front panel of the unit may be removed as a theft deterrent. After removing the front panel, use the case provided to keep the front panel from getting damaged. 1.Press the Open button (3) to flip down the front panel. Initial System Start-Up Be sure to press the RESET button (1) when using the unit for the first time, after all connections are completed correctly. 1. Turn off the unit power. 2.
Sub-woofer: ON/OFF 2. Rotate the VOL button to choose the desired item. Remote control operation Press button (29) to choose the desired item. Display/Adjust Time 1. Displaying time: Press DISP button (7) to show current information and time on the LCD, and it returns to original status after 5 seconds. 2. Adjusting time: 1). Press and hold DISP button (7) until the clock blinking. 2). Press or button to move to between hour area and minute area. 3). Rotate VOL button (6) or to adjust hour or minute.
- Error symbol on the display. Note: If press RESET button(1), the unit can't work yet, please use a cotton swab soaked in isopropyl alcohol to clean the disc socket. Radio Operation Selecting The Frequency Band Press BAND button (14) shortly to select the desired band. The reception band will change between FM and AM. Stereo/Mono Press ST (15) or MO/ST on the remote control to select mono/stereo mode.
Selecting Tracks In Single Step Press button (18) or button (19) to skip to the previous track or the next track. Track number shows on display. Press and Hold button (18) or button (19) to fast reverse or fast forward. It return to normal mode when you release the button. Pause Playback Press button (20) to pause CD/MP3 playing. Press it again to resume playback. Stopping playback - Briefly press the button ( 21 ) to stop the unit playback .
DVD/VCD Operation Playback with PBC Menu For some VCD or SVCD discs , there is menu in order to select the deired contents . This menu is called PBC ( Playback Control ) menu . Press PBC button (37) to toggle between PBC ON and PBC OFF. In PBC ON mode, REPEAT, RANDOM, AB, PROGRAM and GOTO functions are void.
To revert to normal playback, press A-B button again. REPEAT CANCEL Finding The Beginning of Chapters or tracks (Files) Use this function to easily move to the beginning of the chapters or tracks (files) on the disc. During playback, each time p ress button ( 18 ) or button ( 19 ) to skip and play the chapter /track . : Press the button to start playback from the beginning of the next chapter or track (file). : Press the button to start playback from the beginning of the previous chapter or track (file).
GOTO Function Press GOTO button, the screen will display the following message: FOR DVD: Use the number keys (32) to input the desired Title, Chapter or Time, and then press ENTER button (30) to confirm. FOR VCD: according to the disc. - Some discs only contain one subtitle language. Switching the Audio Tracks For some VCD/SVCD discs what with multiple audio tracks, you can switch the audio track temporarily during playback.
ANGLE 1 The angle switches between the angles recorded on the disc each time the button is pressed. Notes: - Some time may be required for the angle to change. - Depending on the disc, the angle may switch in one of two ways. 1 . Seamless: The angle switches smoothly. 2 . Non-seamless: When the angle is switched, a still picture is displayed first, after which the angle switches. - The angle number is different according to the disc.
Data Disc Play Operation When you insert a data disc including audio (MP3), movie (MPEG), picture (JPG) files into the disc slot, the following media play window will be shown on the screen: Explain as follows: Work area A: folders list Work area B: files list Work area C: (1): playback audio mode (default) (2): viewing picture mode (3): playback movie mode Work area D: file information display 1. Press button to move between work area A, work area B and work area C. 2.
the card is in good condition, or take out the card then insert it into the card slot once more. AV In Operation This disc player offers you the option of using the auxiliary A/V input jack to connect a video game, digital camera / camcorder or other units you wish to use in your automobile audio / video system. 1 ).To connect with a automobile audio/video system by AV IN cable. 2 ) . Press the MODE button (13) to toggle the AV IN mode on or off. TV Operation Press MODE button (13) to switch to TV mode.
2. About MP3 What is MP3? MP3, whose official name is “ MPEG-1 Audio Layer 3, ” is a compression standard prescribed by the ISO, the International standardization organization and MPEG which is a joint activity institution of the IEC. MP3 files contain compressed audio data. MP3 encoding is capable of compressing audio data at extremely high ratios, reducing the size of music files to as much as one-tenth their original size. This is achieved while still maintaining near CD quality.
Select AUTO format, the player TV output Change the TV mode among NTSC, PAL and AUTO. The default setting is NTSC format. 16:9 Select this when connected to a wide screen TV. SCREEN SAVER Change the SCREEN SAVER on or off. SETTING the TV TYPE Use the procedure described below to set the output screen according to the type of TV monitor being used. Setting contents: 4:3PS /4:3LB /16:9. For some discs, the picture may not be set to the selected screen size.
LANGUAGE SETUP OSD LANGUAGE AUDIO LANG SUBTITLE LANG MENU LANG DIVX [R] VOD EXIT SETUP You can change the OSD/ AUDIO/ SUBTITLE/ MENU language: OSD LANGUAGE: ENGLISH/GERMAN/SPANISH/FRENCH/PORTU GUESE/ITALIAN/RUSSIAN/POLISH AUDIO LANG: ENGLISH/GERMAN/SPANISH/FRENCH/PORTU GUESE/ITALIAN/ RUSSIAN /POLISH SUBTITLE LANG: ENGLISH/GERMAN/SPANISH/FRENCH/PORTU GUESE/ITALIAN/ RUSSIAN /POLISH MENU LANG: ENGLISH/GERMAN/SPANISH/FRENCH/PORTU GUESE/ITALIAN/ RUSSIAN /POLISH Audio Setup When you open the AUDIO menu, you will
Bluetooth function Tipwizard 1. PAIR During pairing, please input pairing PIN code “8 888 ” and confirm in your mobile phone. 2. CONNECT The bluetooth module can auto connect with your mobile phone so long as you activate the bluetooth of the mobile phone. If connecting success, “ CON OK ” will be visible on the LCD of this unit, otherwise, it will appear “ NO CONT ” on the LCD. Meanwhile, the “BT” and “ ” twinkle continuously on the LCD display. 3. DIAL CALL 3.1 Dial with the mobile phone directly. 3.
7. Voice dialing function If your mobile phone support voice dialing function, you can dial a phone number by voice dialing. Remark: Please operate the voice dial function according to your mobile phone manual. 8. A2DP Function If your mobile phone support A2DP function ( Advance Audio Distribution Profile) that it is special designed for transmitting stereo music to bluetooth device. You can listen to the music stored in your mobile phone by this car audio.
Trouble Shooting If it appears that your DVD unit is faulty, first consult this checklist. It may be that something simple has been overlooked. Do not try to repair the player by yourself, as this will invalidate the warranty. Only qualified service personnel can remove the cover or service this player. No Power ? If the power supply is connected to the car accessory circuits, but the engine is not moving, switch the ignition key to “ ACC ” . ? Check if the fuse is blown. Then replace the new fuse.
Specification 1. GENERAL Power Supply Requirements DC 12 Volts, Negative Ground Chassis Dimensions 178(W)x160(D)x 50(H) Tone Controls - Bass (at 100 Hz) ± 10 dB - Treble (at 10 KHz) ± 10 dB Maximum Output Power 4x60 watts Current Drain 15 Ampere (max.) 2. DVD PLAYER Signal to Noise Ratio > 55 dB Channel Separation > 40 dB Frequency Response 20Hz - 20 KHz 3. RADIO FM Frequency Coverage FM: 87.5 - 107.9 MHz IF 10.
24
