Instruction manual

17
1. GENERAL
2. DVD PLAYER
3. RADIO
FM
AM
Power Supply Requirements
DC 12 Volts, Negative Ground
Chassis Dimensions
178(W)x160(D)x 50(H)
Tone Controls
-Bass(at100Hz) ±10dB
- Treble (at 10 kHz) ±10 dB
Maximum Output Power
4x60 watts
Current Drain
15 Ampere (max.)
Signal to Noise Ratio
>55dB
Channel Separation
>40dB
Frequency Response
20Hz - 20 KHz
Frequency Coverage
FM: 87.5 - 107.9 MHz
IF
10.7 MHz
Sensitivity (S/N=30dB)
4μV
Stereo Separation
>25dB
Frequency Coverage
530 - 1710 KHz
IF
450 KHz
Specification
If it appears that your DVD unit is faulty,
first consult this checklist. It may be that
something simple has been overlooked.
Under no circumstances should you try to
repair the player yourself, as this will
invalidate the warranty. Only qualified
service personnel can remove the cover
or service this player.
If the power supply is connected to the
car accessory circuits, but the engine is
not moving, switch the ignition key to
“ACC”.
Check if select proper mode, such as
Disc Play mode and AV mode.
Check the video connection.
Check if the disc is defective by trying
another disc.
No Power
No Picture
Distorted Picture
Completely Distorted Picture
No Color in Picture
Disc Does Not Play
<
<
<
<
<
<
<
<
<
<
<
<
<
Check if the fuse is blown. Then
replace the new fuse.
Check if the on/off button on the front
of the player is set to on.
Check if the monitor or TV is switched
on.
Check the disc for fingerprints and
clean with soft cloth, wiping from centre
to edge.
Sometimes a small amount of picture
distortion may appear. This is not a
malfunction.
The disc format is not according to the
TV-set used (PAL/NTSC).
The disc format is not according to the
TV-set used (PAL/NTSC).
Ensure the disc label is upwards.
Clean the disc.
Troubleshooting