7” TFT-LCD Monitor w/Built-in DVD/CD/MP3 Player PLDVD7M
Operation Manual Table of Contents Welcome! ----------------------------------------------------------------------- 2 Precautions ---------------------------------------------------------------------3 Installation Installation ----------------------------------------------------------------------4 Operation Monitor Section --------------------------------------------------------------- 5 Adjusting the display setting-------------------------------------------------5 DVD section ---------------------------
Welcome! Thank you for purchasing the 7" headrest TFT-LCD Monitor with DVD Player. For Maximum enjoyment and prolonged life of the DVD player, we strongly recommend that you read the instruction man ual carefully before attempting to operate the unit. Please store this manual in a safe place for future reference. Digital Video Discs are the best source of movies for your life. The latest digital technology allows compression of an entire movie onto one disc.
Precautions T o avoid the risk of serious injury or accident. Please read the following precautions before installing and operating the unit. On Safety IMPORTANT: Always comply with your local traffic rules and regulation. ▓ While driving ●The driver must not watch or operate the monitor. This is a safety hazard and may cause an accident. ●The driver must not listen to or use the headphones. It may be distracting and cause an accident.
Installation ● Place the mounting bar on the poles of headrest and then tighten 4 long screws until the mounting bar is fastening firmly to the headrest poles. ● Put the adapter on the face of L type mounting stand and screw it tightly. ● Slide the engagement nut into the slide bracket slot on the rear of the monitor housing. ● Slide the engagement head on the monitor into the adapter of L-type mounting stand and tighten firmly.
MONITOR SECTION 1. POWER: Press "POWER" for ON/Off. 2. UP : Press "▲" to adjust volume up 3. MENU: Press "MENU" TO select OSD menu 4. DOWN: Press "▼" to adjust volume down.
DVD SECTION To operate DVD by pressing the buttons on up panel: 1. POWER: Press the"POWER" button, insert the disc with printed side facing up into the disc slot, the player starts playback automatically. 2. EJECT: Press"EJECT" button to eject the disc. 3. PLAY/PAUSE: Press once to "PAUSE" a play, press again to resume continuous playback. 4. FORWARD: Press "FF" to forward to next chapter 5. REVERSE: Press "REW" to previous chapter 6.
Operate DVD by Remote Control 1. POWER: To turn the unit ON or OFF. 2. MUTE: Turn off sound. 3. AUDIO: Changes the AUDIO soundtrack on multi-audio soundtrack DVD disc. 4. OPEN/CLOSE: Open or close disc tray. 5. LANGUAGE: Choose different output language. 6. 0-9: Choose number key 7. ANGLE: Changes the viewing angle on multi- angle DVD disc. 8. SUBTITLE: Select or cancel subtitles. 9. EXIT: To exit selection 10. TIMER: Time indication 11. SETUP: Menu setup. 12. VOL-: Decreases current DVD Player volume 13.
34. >>: Press next to skip to the next track 35. BOOKMARK: Memory play 36. A-B: Repeat play segment. Press once to set 37. FORMAT: Switch video output PAL/NTSC. 38. TITLE: Display the TITLE menu that is stored in the DVD disc. 40. MENU: Enter to menu playback. 41. MODE: Switch video input AV1/AV2 Inserting the Batteries 1.Open the battery compartment cover. 2.Insert the new batteries. Make sure that the positive and negative terminals of the batteries are properly followed. 3.
Connection Diagram Refer to the connection diagram for the proper connections. You can make connections shown as below. Please ask a qualified technician for assistance on any other connections. 1.On a towel or soft cloth, gently place the monitor unit "face down" on a stable work surface. 2.Locate the pigtail with the DIN connector. 3.Connect the DIN connector to the interface cable provided. 4.Connect the RED wire to the positive (+) battery terminal. 5.
TROUBLE SHOOTING Symptom and Solution: When having problem with the unit, please check this list for a possible solution before asking for service.
SPECIFICATION DVD PLAYER Power Supply Power Consumption Dimension Video System LaserSL Beam, wave length Frequency Response DVD Audio DC: 12V 25W 22.5cm X 17.5cm X 4.
