”IN -DASH MOTORIZED 7” LCD COLOR MONITOR WITH AM/FM STEREO RADIO MODEL: PLR7N ’ OWNER’ S MANUAL
Any changes or modifications in construction of this device which is not expressly approved by the party ’s responsible for compliance could void the user’ authority to operate the equipment.
! WARNING ”are intended The exclamation point within an equilateral triangle and“WARNING” to alert the user to the presence of important operating instructions. Failure to heed the instruction will result in severe injury or death. DO NOT WATCH VIDEO WHILE DRIVING Watching the video may distract the driver from looking ahead of the vehicle and cause an accident.
! CAUTION ”are intended to The exclamation point within an equilateral triangle and“CAUTION” alert the user to the presence of important operating instructions. Failure to heed the instructions can result in injury or material damage. DO NOT RAISE THE VOLUME EXCESSIVELY Keep the volume at a level, where you can still hear outside noises while driving . Driving while unable to hear outside could cause an accident.
! CAUTION ”are intended to The exclamation point within an equilateral triangle and“CAUTION” alert the user to the presence of important operating instructions. Failure to heed the instructions can result in injury or material damage. Operation of some of the functions of this unit is very complex. Because of this, it was deemed necessary to place these functions into a special SETUP screen. This will restrict operation of these functions to times when the vehicle is parked.
INTRODUCTION MONITOR ⑩ ① ② ⑨ ③ ⑤ ⑥ ⑧ ④ ⑦ ① POWER ON/OFF BUTTON ② MODE SELECTION BUTTON ③ AS/ATM BUTTON ④ SOUND MUTE BUTTON ⑤ VOLUME UP/DOWN ADJUST BUTTON ⑥ SEARCH UP/DOWN BUTTON ⑦ OPEN/CLOSE BUTTON ⑧ TILT UP/DOWN BUTTON ⑨ BAND SELECTION BUTTON ⑩ MENU SELECTION BUTTON 4
REMOTE CONTROLLER ① ① POWER ON/OFF BUTTON ⑥ ⑫ ⑤ ② MODE SELECTION BUTTON ③ AS/ATM BUTTON ④ SOUND MUTE BUTTON ③ ④ ② ⑨ ⑤ VOLUME UP/DOWN BUTTON ⑥ SEARCH UP/DOWN BUTTON ⑩ ⑦ OPEN/CLOSE BUTTON ⑧ MANUAL MEMORY BUTTON ⑨ CHANNEL UP/DOWN BUTTON ⑪ ⑦ ⑩ NAVIGATION BUTTON ⑧ ⑪ ASPECT BUTTON ⑫ MENU SELECTION BUTTON 5
REMOTE CONTROL UNIT Replacing battery Applicable battery : Use two“AAA”sized dry batteries. 1. Opening the battery cover. Push and slide the cover in the arrow direction, and the cover will be removed. 2. Replacing the battery. Remove the old batteries. Insert new ones matching the (+) and (-) polarities as shown in the diagram inside the unit. 3. Closing the cover. Push the cover in the arrow direction until a click is heard.
BASIC OPERATION POWER ON / OFF RADIO MAIN MENU 1. POWER ON 1) Press the POWER button to turn the power on. But the monitor will not open. 2) You can also turn the power on by pressing the OPEN/CLOSE button. The power will be on and the monitor will open. 2. POWER OFF 1) Press the POWER button again to turn the power off. 2) If you turn the power off by pressing the POWER button when the monitor opens, the monitor will not close.
CLOSING THE MONITOR 1. Hold left and right upper side of the monitor and set the left and right angle of the monitor parallel with the front of the unit as the picture. 2. Press OPEN/CLOSE button. The monitor will close. NOTE 1. If the left and right angle of the monitor is not parallel to the front of the unit, the monitor can not be closed. 2. If the OPEN/CLOSE button is pressed while radio or video is on, the monitor will close. But the sound is still on. Press the POWER button to turn the sound off.
ADJUSTING THE SLIDE POSITION 1. Press the MENU button repeatedly on radio or AV mode until the USER SELECTOR menu is selected. 2. Press the SEARCH UP/DOWN button to select MOVE 3. Press the VOLUME ▶ button to select FORWARD. The monitor will slide one step (15mm) to the front. 4. Press the VOLUME ◀ button to select BACKWARD. The monitor will slide one step (15mm) to the back. For more information, see page 21 of owner’s manual. NOTE 1.
SELECTING MODE Press the MODE button to select the desired mode. Each time you press the button, the mode changes as follows. RADIO -> AV1 -> AV2 -> AV3 (CD OR VCD CHANGER) -> AV4 (TV) NOTE 1. AV3 has only video input. 2. The CD/VCD changer must be connected to the 8 pin DIN socket on the rear of the unit with 8 pin DIN cable in our CD/VCD changer gift box. 3. The video output of VCD changer must be connected to AV3 video input.
ADJUSTING THE TV/VIDEO PICTURE MODE (ASPECT) Each time you press A (ASPECT) button, the picture mode switches between Normal, Full, Zoom and Wide. NORMAL MODE The monitor displays normal picture at the center of the screen with the proportion of 4 to 3. The screen shows a vertical black belt at each side. FULL MODE The monitor displays normal picture wider by stretching out horizontally with the proportion of 16 to 9.
RADIO CONTROL Press the OPEN/CLOSE button to turn the power on and to open the monitor. The monitor shows following picture. RADIO MAIN MENU NOTE 1. Each time you press the MENU button on RADIO MAIN MENU screen, the menu on the screen changes as follows. RADIO SUB -> VOLUME -> USER SELECTOR -> PICTURE -> RADIO MAIN 2. You can select the items on each menu by pressing the SEARCH UP/DOWN button. 3. You can adjust the level of the selected items by pressing the VOLUME or CH UP /DOWN button.
AUTO MEMORY OF STATION 1. Tune in desired radio station you wish to store on the CH number. 2. Press the AS/ATM button for at least 2 seconds. The frequency on the display continues to change while the auto memory is in progress. The tuner will automatically seek and can store up to 30 stations in each band in order of frequency signal. They can be stored in FM1: 30, FM2: 30, AM1: 30 and AM2: 30 stations (total 120 stations). 3.
RADIO BAND 1. Press the SEARCH UP/DOWN button to select RADIO BAND. 2. When RADIO BAND is selected, press the VOLUME ◀ or ▶ button to select the band. Each time you press the VOLUME ◀ or ▶ button, the band switches as follows. FM1 -> FM2 -> AM1 -> AM2 3. You can also select the band by pushing the BAND button on the unit. Each time you press the BAND button, the band switches as follows. FM1 -> FM2 ->AM1 -> AM2 TREBLE 1. Press the SEARCH UP/DOWN button to select TREBLE. 2.
NAVIGATION SETTING THE NAVIGATION 1. Connect a NAVIGATION system only to AV1 or AV2 Input terminals on the rear of the unit. 2. Press the MODE button to select radio mode. 3. Press the MENU button to select following picture. RADIO SUB MENU 4. Press the SEARCH UP/DOWN button to select NAVIGATION. 5. Press the VOLUME ◀ or ▶ button to select AV1 or AV2 that NAVIGATION system is connected to.
CAMERA IN SETTING THE CAMERA IN 1. Connect a Back View Camera video output only to AV1,2 or 3 video Input terminals on the rear of the unit. * When the VCD changer is connected to AV3 Video input, The back view camera can be connected only to AV1 or AV2 video input. 2. Press the MODE button to select radio mode. 3. Press the MENU button to select following picture. RADIO SUB MENU 4. Press the SEARCH UP/DOWN button to select CAMERA IN. 5.
CD CHANGER CONTROL When a CD (VCD) changer is connected to this unit with 8 pin DIN cable, AV3 mode changes to CDC mode and CDC control menu is displayed on the screen. 1. Press the MODE button to select CD CHANGER (AV3) mode. Each time you press this button, the display changes as follows. RADIO-> AV1-> AV2-> AV3 (CD or VCD CHANGER) -> AV4(TV) 2. When CD CHANGER (AV3) mode is selected, The monitor shows following picture. 3. Press the SEARCH UP/DOWN button to select the item. 4.
TRACK NUMBER 1. Press the SEARCH UP/DOWN button to select TRACK NUMBER. 2. Each time you press the CH UP button, the next track number will be selected forward and the displayed track number increases by one. 3. Each time you press the CH DOWN button, the previous track number will be selected and the displayed track number decreases by one. INTRO SCAN 1. Press the SEARCH button to select INTRO SCAN. 2. Press the CH UP/DOWN button to select the item.
DIRECT CD CHANGER CONTROL On the CD changer mode, you can directly control CD changer functions just by pressing the buttons on the remote controller for our monitor unit. STOP ■ button PAUSE button PLAY REW button button FF button DISC + button DISC - button TRACK+button TRACK - button : to make the playing of the disc stop. : to stop the playing of the disc . press again to play again. : to make the disc play. : to quickly move backward of the disc until you reach the desired section of the track.
VOLUME ADJUSTMENT OF EACH CHANNEL You can adjust the volume level of each channel of the radio or AV sources connected to this unit. ADJUSTING THE VOLUME OF EACH CHANNEL 1. Press the MENU button repeatedly on radio or AV mode until VOLUME MENU is selected The monitor shows following picture. VOLUME MENU 2. Press the SEARCH UP/DOWN button to select the audio channel that you want to adjust. 3. Press the VOLUME ◀ or ▶ button to adjust the volume level of the selected audio channel. DEFAULT 1.
FINE ADJUSTMENT FOR CENTER FREQUENCY AND TILT/SLIDE POSITION 1. Press the MENU button when the monitor shows following picture. VOLUME MENU The monitor shows following picture. USER SELECTOR MENU USER SELECTOR TILT POSITON MOVE 0 FORWARD 2. Press the SEARCH UP/DOWN button to select the items that you want to adjust. 3. Press the VOLUME ◀ or ▶ button to adjust the level of the selected item.
SCREEN CONTROL 1. Press the MENU button when the monitor shows following picture. USER SELECTOR MENU USER SELECTOR TILT POSITON MOVE 0 FORWARD The monitor shows following picture. PICTURE MENU 2. Press the SEARCH UP/DOWN button to select the items that you want to adjust. 3. Press the VOLUME ◀ or ▶ button to adjust the level of the selected item.
SELECTING COLOR/SOUND SYSTEM 1. Press the SEARCH UP/DOWN button to select COLOR SYSTEM for the video source on PICTURE menu. PICTURE MENU 2. Press the VOLUME ◀ or ▶ button to select PAL or NTSC for the video source. NOTE To select the color system for the TV when the TV tuner box is connected to the AV4 input of this unit, 1. Select color system (PAL or NTSC) for the video source at COLOR SYSTEM on PICTURE menu on radio mode first. 2.
VOLUME CONTROL ON AV MODE To adjust audio level of AV sources on AV mode, 1. Press the VOLUME ◀ or ▶ button. The monitor shows following picture. 2. Press the SEARCH UP/DOWN button to select the items that you want to adjust. 3. Press the VOLUME ◀ or ▶ button to adjust the audio level of the selected item. NOTE 1. Each time the MENU button is pressed on AV1, 2 or 3 mode, the menu is selected as follows. VOLUME -> USER SELECTOR -> PICTURE 2.
WARNING SCREEN The monitor shows following warning picture when the parking brake is not set or when driving to prevent traffic accident that may be caused while watching the screen. The monitor shows the warning picture only and does not show any other pictures, but you can enjoy the sound only by adjusting the volume.
AV INPUT FACE PLATE OF THE UNIT Video Audio Yellow : Video White : Audio Left Red : Audio Right Front View NOTE 26 3.5 Ø AV input on the front face of the unit is same input with AV1 input on the rear of the unit. If the sources are connected both input terminals,the 3.5Ø input has priority in working.
INSTALLATION PRECAUTIONS Choose the mounting location carefully so that the unit will not interfere with the normal driving functions of the driver. Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight or hot air from the heater, or where it would be subject to dust, dirt or excessive vibration. Use only the supplied mounting hardware for a safe and secure installation. Be sure to remove the front panel before installing the unit.
BASIC CONNECTIONS REMOTE TURN-ON (Blue/White) To amplifier or equalizer AUTO ANT (Blue) To power antenna PARKING BRAKE (Brown) To the parking brake signal lead ACC (Red) (Yellow) BATTERY (MEMORY) (Black) (Orange) Ignition Key GROUND REVERSE GEAR - + Battery SPEAKER REAR LEFT SPEAKER FRONT LEFT + (Gray/Black) (Violet/Black) Front right - (Violet) (Green) Rear right + Speakers (Green/Black) (White/Black) Rear left - SPEAKER REAR RIGHT (Gray) + SPEAKER FRONT RIGHT (White) Front
Ext. AV 1 Yellow White Red Sub Woofer Rear Left Rear Right Front Left Front Right Video Left Right AV-1 INPUT Yellow White Red White Red PRE AMP RCA LINE OUT ANT. TV Tuner Box 4PIN DIN CD (VCD) Changer 4PIN DIN Video in (Yellow) V 3 INPUT Red White Right Left AV4 Input TV Tuner Input Yellow Video Video out (Yellow) 8P Din 16P Connector VIDEO in Ext. Monitor Yellow Yellow Video VIDEO out White Red Left Right AV2 INPUT Ext.
SPECIFICATIONS AM SECTION USA BAND Frequency Range Frequency Step EUROPE BAND Frequency Range Frequency Step Intermediate Frequency Usable Sensitivity Image Rejection Ratio IF Rejection Ratio 530-1710KHz 10KHz 522-1620KHz 9KHz 450 KHz 32 dB 45dB 100dB FM SECTION Frequency Range Frequency Step Manual tuning Seek tuning Intermediate Frequency Usable Sensitivity Image Rejection Ratio IF Rejection Ratio 87.5~108 MHz 50 KHz 100KHz 10.
Printed In Korea