Fixed Flat Panel TV Bracket Installation Guide

ManualsBrandsPYLE Audio ManualsFlat Panel TVPSW112

Warning: Some TV require two people to lift, as we are not responsible for any

personal injury or product damage due to mishandling.

Warning:

Fig 3a Fig 3b

Item No.:PSW112Item No.:PSW112

Step 3: Hanging display

Firstly lift the bracket mounted display over the wall mount. And then hook the

brackets over the top of the wall mount. Rotate the display let the bottom of the

brackets hook over the bottom of wall mount, as shown in Fig.3a. Then put safe

bolts into the bottom of the brackets and lock it, as shown in Fig.3b.

Step 3: Hanging display

Fig 2b

Fig 2c

-8-

Multifunctional double deck wall mount

Fixed Flat Panel TV Bracket

INSTALLATION GUIDE

IMPORTANT: If don’t understand about right install ways, please

consult to normal installing specialist.

IMPORTANT:

Easy installing: Just hang up the display

Safety: locking by spining bolt on the bottom

Max load capacity:75kg(165lbs

TV size range: 36 ~55

）

Brick, Concrete and Stone wall(Fig 2c):

Using the wall mount as template to mark 6 holes location on the wall. There holes are

located at the top row of the slots and three more are located at the bottom row. The

outer holes must be fall to the left and right of the two holes in the middle of the

mount. Please make sure these holes are level and at least 6” between any two lines.

Pre-drill these holes with a 10mm drill bit to at least 80mm deep hole. Insert Wall

anchors(P) into each of these holes. Attach the wall mount to the wall using 6 Long

bolts(O) and washers(Q).

Brick, Concrete and Stone wall(Fig 2c):

2,3

Summary of content (4 pages)

PAGE 1
Brick, Concrete and Stone wall(Fig 2c): Using the wall mount as template to mark 6 holes location on the wall. There holes are located at the top row of the slots and three more are located at the bottom row. The outer holes must be fall to the left and right of the two holes in the middle of the mount. Please make sure these holes are level and at least 6” between any two lines. Pre-drill these holes with a 10mm drill bit to at least 80mm deep hole. Insert Wall anchors(P) into each of these holes.
PAGE 2
Hardware List: Step 2: Attach mount to wall 3 2 First, determine the height of stand The best height of stand is parallel to eyelevel of a person who sitting on a couch. Normally, the horizontal distance of eyelevel is about 4’ from ground level. The following two conditions are for determining the perfect height of stand: 1) the distance between wall and couch(Fig 2a).
PAGE 3
. For display with protruding HDTV tune or deeply cur ved backs(Fig b), two 9/16” spacers(R) or two ½” spacers(S) should be used. Stack two spacers and then install them between display and the bracket. As shown in Fig 1c. WARNING Fig b M4 Fig bit We are not responsible for any personal injury or product damage due to mishandling, incorrect mounting, incorrect assembly or incorrect use of this product.
PAGE 4
Following examples shows how to use bolts, spacers and square washers. 1.Some displays have vertical backs. No spacer is required. Install the bracket directly to the back of display by using bolts and square washers provided. As shown in Fig.1a. M4 Fig bit M5 Fig bit N 2. Some displays have cur ved backs with recessed mounting lands(Fig.a). It will require the use of spacer. For this display, install a 9/16” spacer(R) or ½”spacer(S) between display and the bracket. As shown in Fig 1b.