PLPK5TVD COLOUR LCD TV/RECEIVER OWNER'S MANUAL

ManualsBrandsPYLE Audio ManualsCar Video SystemView Series PLPK5TVD

PLPK5TVD

OWNER’S MANUAL

COLOUR LCD TV/RECEIVER

Summary of content (20 pages)

PAGE 1
PLPK5TVD OWNER’S MANUAL COLOUR LCD TV/RECEIVER
PAGE 2
INSTALLATION Notes: • Choose the mounting location where the unit will not interfere with the normal driving function of the driver. • Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly. • Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions.
PAGE 3
MOUNTING THE TUNER UNIT 4 2 6 6 5 4 7 1 6 3 1 8 5 7 5 7 3 8 2 Step 1 1. 2. 3. 4. Step 2 Bracket (A) Mounting Bolt (M5 x 5) Bracket (B) Hexagonal Bolt with Washer (M6 x 12) 5. 6. 7. 8. Tapping Screw with Washer (M5 x 12) Spring Washer (M6) Spring Washer (M5) Double Sided Tape INSTALL THE DISPLAY UNIT Before install the display unit, please remove its tail screw and cable parts.
PAGE 4
1. Dashboard 1 2. Nut (M5) 6 4 3. Spring Washer 4. Tapping Screw with Washer (M5 x 25) 2 7 5. Screw 5 3 6. Plain Washer 7. Strap Be sure to use the strap to secure the back of the unit in place. The strap can be bent by hand to the desired angle. (Fig. 2) Removing the unit 1 1. Lever Insert the levers supplied with the unit into the grooves at both sides of the unit as shown in figure until they click. Pulling the levers upward and out to makes it possible to remove the unit.
PAGE 5
HOW TO OPEN AND CLOSE THE SCREEN DISPLAY 1. Press release button to draw out the screen display. Release Button 2. Turning the display upward. 3. Adjusting the viewing angle. Angle should be adjusted slowly without applying unreasonable force.
PAGE 6
4. Turning the display downward. Make sure to return the display to centre position before drawing in. It cannot be draw in with its angles adjusted. 5. Push the panel, the display will be drawn in.
PAGE 7
FRONT Lch SPK FRONT Rch SPK REAR Lch SPK REAR Rch SPK VIOLET WHITE/BLACK WHITE GREY/BLACK GREY GREEN/BLACK GREEN VIOLET/BLACK GREY/BLACK GREY CHOKE BOX TV CONTROL 7 Lch WHITE Rch RED Lch WHITE (FOR RCA LINE VERSION ONLY) REAR RCA CABLE FRONT RCA CABLE GREY PLUG BLACK PLUG AV1 BLACK/GREY CABLE AV INPUT BLACK CABLE RADIO/TV MAIN UNIT (VIEW FROM REAR) FROM VIDEO/AUDIO SOURCE VIDEO OUTPUT 75ohm RF WIRE (BLACK) (GREY) (BROWN) RADIO ANTENNA INPUT TV DIVERSITY ANTENNA INPUT Rch R
PAGE 8
OPERATION 16 11 7 24 1 5 6 8 19 10 20 9 4 12 2 15 18 21 22 8 3 17 1 13 14 23 4
PAGE 9
GENERAL OPERATION • ON/OFF Switch on the unit by pressing PWR button (1). When system is on, press it again to turn it off. • FACEPLATE RELEASE Press REL button (2) to draw out the faceplate, push the panel to draw in. When the faceplate is drawn out, turn the faceplate upward and adjust TV display. • SELECTING SOUND MODE Press SEL button (6) to move display through volume, bass, treble, balance and fader functions. Use (7) and (8) buttons to adjust the selected mode.
PAGE 10
Time Setting - Set hours: Holding down T/F button (5) for several seconds, and the clock is blinking on the display, press button (14) to adjust the hour. - Set minutes: Holding down T/F button (5) for several seconds, and the clock is blinking on the display, press button (13) to adjust the minutes. • LIQUID CRYSTAL DISPLAY The LCD (4) can show the current state of the unit. • RESET Reset button (24) must be activated with either a ball-point pen or thin metal object.
PAGE 11
RADIO OPERATION • SELECTING BAND Press BAND button (11) to change between three FM bands and two AM bands. Each band stores up to six preset stations. FM1 FM2 FM3 AM1 AM2 • SELECTING STATION During radio mode, press MAN/SKP button (13) to increase frequency or (14) to decrease frequency by one step of channel spacing. Hold the button longer for fast tuning. The frequency is updated correspondingly on display. • SELECTING MEMORY Press preset memory buttons (15) to preset stations at tuner mode.
PAGE 12
TV OPERATION • SELECTING RECEIVING MODE Press TV/AV button (17) to select among TVch/AV1/AV2. • SELECTING CHANNEL Press CH+ button (9) or CH– button (10) to choose channel upward or downward • MENU CONTROL In TV mode Press MENU button (18) to switch the MENU CONTROL mode. And the main menu includes three sub-menus: PICTURE MENU, TUNER MENU and SYSTEM MENU.
PAGE 13
Note: When you set the color mode to “PAL” in SYSTEM MENU, there is no “TINT” item to display. In this menu, the range of setting value is 00~63, and the recommended range of these values are listed below: BRIGHT: 10~32 CONTRAST: 20~40 COLOR: 40~50 SHARP: 63 TINT: 10 TUNER MENU --POSITION -TUNER MENU POS SKIP BAND FINE AFT SEARCH ASM 1 ON UHF OFF POSITION setup You can use numeric buttons to input the TV channel number.
PAGE 14
--BAND-TUNER MENU POS SKIP BAND FINE AFT SEARCH ASM 1 ON UHF OFF BAND setup You can use CONTROL+ button (19) or CONTROL– button (20) to switch between UHF, VHFL and VHFH band. --FINE-TUNER MENU POS SKIP BAND FINE AFT SEARCH ASM 1 ON UHF OFF FINE setup When the frequency has warp, and the picture displayed unstable, you can use CONTROL+ button (19) or CONTROL– button (20) to start FINE function to adjust it.
PAGE 15
--SEARCH-TUNER MENU POS SKIP BAND FINE AFT SEARCH ASM 1 ON UHF OFF SEARCH setup Use CONTROL+ button (19) or CONTROL– button (20) to start manual station search. And it will start from the band you select in BAND setup. The SKIP and AFT two items will be set automatically. --ASM-TUNER MENU POS SKIP BAND FINE AFT SEARCH ASM 1 ON UHF OFF ASM (Auto Search Memory) setup Use CONTROL+ button (19) or CONTROL– button (20) to start auto station search. The SKIP, BAND and AFT three items will be set automatically.
PAGE 16
COLOR setup Use CONTROL+ button (19) or CONTROL– button (20) to switch color mode among AUTO, PAL, N3.58 and N4.43. --SOUND-SYSTEM MENU COLOR SOUND LANG. B/B CORING HALFTONE AUTO M ENGLISH ON ON ON SOUND setup Use CONTROL+ button (19) or CONTROL– button (20) to switch sound mode among M, B/G, I and D/K. --LANG.-SYSTEM MENU COLOR SOUND LANG. B/B CORING HALFTONE AUTO M ENGLISH ON ON ON LANG. (Language) setup Use CONTROL+ button (19) or CONTROL– button (20) to switch between ENGLISH and CHINESE.
PAGE 17
--CORING-SYSTEM MENU COLOR SOUND LANG. B/B CORING HALFTONE AUTO M ENGLISH ON ON ON CORING setup Use CONTROL+ button (19) or CONTROL– button (20) to switch between ON and OFF. When the coring function is on, it can effectively decease the picture noise and improve the image quality. --HALFTONE-SYSTEM MENU COLOR SOUND LANG. B/B CORING HALFTONE AUTO M ENGLISH ON ON ON HALFTONE setup Use CONTROL+ button (19) or CONTROL– button (20) to switch the menu background between ON and OFF.
PAGE 18
• PROGRAM SCANNING Press SCAN button (22), “SCAN OFF” will display on the lower left corner of the screen. Press it again, the screen will display “SCAN ON”, then it begins to scan 1.5 seconds of each channel in sequence. When it completes, the screen will display “SCAN OFF”. In the course of scanning, press SCAN button (22), “SCAN OFF” will also display on the screen and it stops on the TV channel just scanning.
PAGE 19
REMOTE CONTROL HANDSET 1 2 3 16 4 5 17 6 8 7 9 10 13 11 14 12 15 CONTROL & FUNCTION KEYS 1. 2. 3. 4. 5. POWER TV/AV 0-9 -/-MUTE = = = = = 6. 7. 8. 9. 10. 11. 12. SCAN MENU / / VOL + VOL – PICT = = = = = = = 13. 14. 15. 16. RETURN CH + CH – DSP = = = = 17. SORT = Press POWER to turn the unit ON or OFF Switch between TV/AV1/AV2 Numeric buttons, press to select the corresponding channel Digital selecting button, cooperatively used with numeric buttons Press to mute the sound.
PAGE 20
SPECIFICATION GENERAL Power Supply Voltage Maximum Power Load Impedance Tone Controls - Bass (at 100 Hz) - Treble (at 10 KHz) : DC 12 Volts, Negative Ground : 4 x 60 Watts : 10 Ampere (max.) : + / – 10 dB : + / – 10 dB TV Monitor Screen Size Resolution TV Sensitivity : 5.0” TFT : 960 x 234 dots : 45 dBµV/PD (max.) @CH25 in average RADIO FM 87.5 to 107.