- Pyle OWNER'S MANUAL DVD Player PLPK65TVD

SOUND ADJUSTMENT

Press SEL button (10) to select the desired adjustment mode.

The adjustment mode will change in the following order:

Volume Bass Treble Balance Fader

By pressing VOL button (11) or VOL button (12), it is possible to adjust the

desired sound quality.

LOUDNESS

Press BND/LOU button (13) for several seconds to reinforce the bass output and

display will show “LOUD”.

Press it for several seconds again to release this function.

SELECT MODE

Press MOD button (6) to choose desired listening mode.

(e.g. radio mode to cassette mode to CDC mode or AUX IN mode)

SET THE CLOCK

Holding down the DSP button (15) until the clock is shown on the display and flashes.

Then press the TUNE/SEEK button (17) to change hours or TUNE/SEEK button

(16) to change minutes.

MUTE

Press MUT button (3) to silence the receiver. Press it again to resume listening.

VACUUM FLUORESCENT DISPLAY

Exhibit current frequency and activated functions on the display (8).

EQUALIZATION

Press EQ button (19) to turn on equalization function and to select desired audio

mode.

There are five kinds of mode as below:

FLAT CLASSICS POP JAZZ DSP OFF

REMOTE SENSOR (OPTIONAL)

Point the remote control handset to the remote sensor RX (27).

Press the function keys on the handset to control the system.

FLASHING LED

If the front panel does not install in the unit, the LED (29) will be flashing.

RESET

RESET button (30) must be activated with either a ball point pen or thin metal object.

RESET button (30) is to be activated for the following reasons:

- Initial installation of the unit when all wiring is completed.

- All the function buttons do not operate.

- Error symbol on the display.

Note: If press RESET button (30), the unit can’t work yet, please use a cotton swab

soaked in isopropyl alcohol to clean the socket on the front panel.