PLTV165 OWNER'S MANUAL Mobile Video System Vertical Adjustable And Horizontal Rotatable Panel TFT Monitor With TV Tuner Remote Control www.pyleaudio.
CONTENTS Important Safety Instruction ....................................................... 3 Installation .................................................................................... 4 DIN Front-Mount (Method A) ......................................................... 4 Installing the unit ......................................................................... 4 Removing the unit ....................................................................... 5 DIN Rear-Mount (Method B) ...............
IMPORTANT SAFETY INSTRUCTION CAUTION: Please read and observe all warnings and instructions given in this owner's manual. Keep these instructions. Retain this booklet for future reference. Please read the following safety instructions carefully. 1.This set has been designed and manufactured to assure personal safety. Improper use can result in electric shock or fire hazard. The safeguards incorporated in this unit protect you if you observe the following procedures for installation, use and servicing.
INSTALLATION TAKE OUT SCREW BEFORE INSTALLATION Notes: Choose the mounting location where the unit will not interfere with the normal driving function of the driver. Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly. Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause Malfunctions.
INSTALLATION (Tapping Screw (5x25mm) and Plain Washer) to attach the other end of metal strap to a solid metal part of the vehicle under the dashboard. This strap also helps ensure proper electrical grounding of the unit. Sleeve L Key Outer Trim Ring R Key Spring Washer Hex Nut Metal Strap 5. Mount the sleeve by inserting the sleeve into the opening of the dashboard and bend open the tabs located around the sleeve with a screwdriver.
INSTALLATION DIN REAR-MOUNT (Method B) 3 1 2 4 5 1. 2. 3. 4. 5. Factory radio mounting bracket Car radio mounting bracket Screw After aligning the car radio mounting bracket with the factory radio mounting bracket, tighten the screws (5x5mm) at 2 places on each side. When fix the factory radio mounting bracket with the screws, use s standard-tipped screwdriver to open the tabs of the car radio mounting bracket to make them fit into theholes in the factory radio mounting bracket.
3A RED MEMORY BACK-UP (YELLOW) GND (BLACK) ACC (RED) AUDIO R OUT REMOTE CONTROL RECEIVER AV INPUT WHITE YELLOW RED WHITE YELLOW TV ANT AUDIO L OUT VIDEO OUT AUDIO 2 R IN AUDIO 2 L IN VIDEO 2 IN ELECTRICAL CONNECTION REMOTE AV OUT DC IN To Diversity Antenna RGB SYSTEM
OPERATION LOCATION AND FUNCTION OF KEYS 7 1 3 2 4 6 9 8 10 11 12 8 13 15 16 14 5
OPERATION LOCATION AND FUNCTION OF KEYS 18 19 17 21 20 22 23 26 28 24 29 27 30 25 1. /I POWER 2. OPEN/CLOSE 3. IR 4. AUDIO IN (AV1) 5. VIDEO IN (AV1) 6. 6.5 inch MULTI COLOR TFT MONITOR 7. Reset 8. VOLUME 9. VOLUME 10. MENU 11. TV/AV 12. AUTO 13. IR 14. CHANNEL 15. CHANNEL 16. 4:3/16:9 Selector 17. POWER 18. OPEN/CLOSE 19. TV/AV 20. 0~9 Numeric buttons 21. ANGLE+ 22. ANGLE23. AUTO 24. VOLUME ^ 25. VOLUME 26. CHANNEL ^ 27. CHANNEL 28. -/-29. DSP 30.
OPERATION SWITCHING ON/OFF THE UNIT Switch on the unit by pressing POWER button (1) on the front panel or POWER button (17) on the remote control. When system is on, press it again to turn the unit off. OPEN/CLOSE THE MONITOR AND ANGLE ADJUSTMENT Press OPEN/CLOSE button (2) on the front panel or point the remote control to IR (3) on the front panel and press OPEN/CLOSE button (18), the monitor will stretch automatically. Fig.
OPERATION Notes: The external remote receiver is placed near the monitor for the best to receiver remote signal easily. If the angle of the monitor from vertical 0 exceeds 20 (Especially the distance exceeds 3m.), controlling the TV through IR (3) or (13) cannot get good effect. You are suggested to use the external remote receiver. 6.5 inch TFT DISPLAY When the monitor stretches out, the 6.5 inch color TFT display (6) can show the current state of the unit.
OPERATION Auto Searching channels Press AUTO button (12) on the monitor panel or AUTO button (23) on the remote control to enter into auto searching mode, then press CHANNEL button (14) on the monitor panel or CHANNEL ^ button (26) on remote control t to start searching TV channels. Then press CHANNEL button (15) on the monitor panel for about ^ one seconds or press CHANNEL button (27) on the remote control to stop searching.
www.pyleaudio.