User's Manual

www.PyleUSA.com
6
www.PyleUSA.com
7
System connection ow diagram
Installation of Reciever
• Keep the machine 1m above the ground
• Keep the machine away 1m against the wall.
• Fully pull the antenna up
• Make the transmitter point to the antenna without barrier
• Keep the reciever away any digital equipment (such as CD, VCD, PC, or other
radio equipment)
TROUBLESHOOTING
Some problems and their solutions are identied in the table below. If you are
unable to solve a problem, contact your dealer.
Problem Solution
No sound; RF light(s)
not glowing
• Make sure the transmitter is ON
• POWER switch is ON and the receiver is piugged
into a power source. Check battery.
• Check receiver squelch setting.
• Check receiver antenna connection(s}.
• Make sure antennas are in line of sight of
transmitter.
No sound;
RF lights glowing.
• Turn up receiver audio VOLUME control
• Check for proper connection between receiver
and karaoke unit
Problem Solution
Received signal is noisy.
Contains extraneous
sounds. Theres sound
while transmitter is ON.
• Check the battery
• Remove local Sources of RF interference.
• If using a guitar or other instrument, check
connections.
• Two transmitters may be operating on the same
frequency. Locate and turn one o.
• Signal may be too weak. Reposition antennas.
lf possible, move them closer to the transmitter.
Noise from receiver
while transmitter is o.
• Adjust receiver squelch control.
• Remove localsources of RF interference.
• Reposition receiver or antennas.
Momentary loss of sound
as transmitter is moved
around performing area.
Reposition receiver and perform another
“walk through” test and observe the RF indicators.
If audio drop outs persist, mark these “dead spots”
in performing area and avoid them during
performance.