User's Manual

www.PyleUSA.comwww.PyleUSA.com
4 5
RECHARGEABLE BATTERY OPERATION
This unit can be powered internally using the built-in rechargeable battery.
When AC power is connected, if battery charging indicator lights red, the
rechargeable battery is not fully charged and will be allowed to charge while
the unit is powered by the AC power.
Note:
Turning o the unit power switch will allow the battery to recharge more
quickly.
If the battery charging indicator lights green, the battery is fully charged and
ready to power the unit alone. Shut o the power switch and disconnect the
AC power. Turn the unit back on and the rechargeable battery will power the
unit alone.
CONNECTION
The REC OUT socket can be connected to a recording device or to the input
jack of a power amplier to further amplify and enlarge the audio power.
The MIC IN socket can be connected to wired dynamic MIC.
Keep MIC head away from the speaker of main unit to avoid feedback.
BLUETOOTH/MP3 OPERATION
1. Insert ash drive into USB port or Micro SD Memory Card into Micro SD
Memory Card Slot, system will play the music in ash drive or Micro SD
Memory Card automatically. If both ash drive and Micro SD Memory Card
are inserted, system will play the music in ash drive. To play music in
Micro SD Memory Card press MODE button to switch to SD mode.
2. To play music from your mobile phone etc via bluetooth, press MODE
button to switch to BT mode. Turn on bluetooth function of your mobile
phone and search for Pyle Audio and connect. Then you can play your
music in mobile phone.
ATTENTION:
1. If feedback (howling sound) occurs, try rst turning down the treble
control. If feedback still is present, try turning down the volume or
repositioning this unit with respect to the wired or wireless microphone
being used.
2. Extend the antenna fully whenever using the wireless microphone to
ensure optimum performance and maximum range.
OPERATION OF WIRELESS MICROPHONE
1. Open battery cover and install 2PCS AA batteries into battery
compartment with correct polarity. Then close the battery cover.
2. Slide power switch to “ON” position to turn on the microphone.
Power indicator will ash once and then go o. This indicates correct
operation.
3. The RF indicator on the amplier should now be lit.
4. Adjust the wireless MIC volume control of the amplier to a comfortable
listening level as desired.
5. Slide power switch to center “MUTE” position to mute the sound.
6. During operation if power indicator lights red, this indicates the battery is
Iow. Please replace new battery.
7. If the microphone is not going to be used for any length of time, slide
power switch to OFF position and remove the battery.
BELT PACK TRANSMITTER OPERATION
Battery Cover/Compartment
Power Switch
Power/Low Battery Indicator
Grille(capsule inside)
5
4
1
2
3
6
7
1. Power On/Off/Mute switch
3. Power/low battery Indicator
4. Gain adjustment
5. Battery compartment/cover
6. Lapel MIC
7. Headset MIC
2. MIC input socket