2-WAY Motorcycle alarm system All rights reserved The trademark, patent and copyright are owned by Steelmate Co., Ltd.
Contents User's Manual Installation Manual Important notice -------------------------------------- 01 886 series installation guide ---------------------- 06 Key features ------------------------------------------ 01 986 series installation guide ---------------------- 08 Technical parameter -------------------------------- 02 ECU installation -------------------------------------- 10 Brief look at each device -------------------------- ECU light installation ------------------------------- 02 1
Important notice Please install the system by an authorized engineer Keep the product and the transmitters from water. It is highly recommended you read this manual carefully before the installation and operation of this unit. When the transmitter operating distance is shorter or its indicator light turns dark, please replace the battery with a new one or charge the transmitter ASAP Technical parameter Transmitter charging ECU Operation voltage: 12V 3V Static current: <3.5 mA Operation frequency: 433.
Functions 1. Arming When ignition is turned to off, press arm the system. 2. Mute arming Press button twice (or muet arming mode. button to button once) to enter 3. Shock impact alarm In arming mode, the first shock impact will trigger the system warning, the siren will chirp with turn signals flashing 3 times, and the engine will be immobilized. The 2-way transmitter will beep 5 times with vibration, the icon and icon will be flashing with backlight.
886 series installation guide AC ignition installation diagram Installation Manual Flameout wire 05 06
986 series installation guide DC ignition installation diagram AC ignition installation diagram Fuse Flameout wire 07 Flameout wire 08
DC ignition installation diagram ECU installation Siren installation Please mount the ECU downside as shown in the figure. Please mount the siren downwards as shown in the figures 1 or 2 below 1 ECU light installation Fuse 2 Flameout wire 1. Drill a hole ( 8) around the block where it can be seen clearly. 3 2. Insert the outer bushing to the hole. 3. insert the inner bushing with LED to the outer bushing and tighten them up. 4. Connect the LED plug to the main unit of the alarm system.
Troubleshooting 1). Transmitter is ineffective or the control distance decreased significantly. l Tall building, radio tower or high frequency electromagnetic wave may affect the control range. l Low power of the battery. l The transmitter is broken or damaged. l The installation location of the antenna is wrong. You should straighten the antenna and keep it away from other wire harness. 2). The siren does not chirp when the alarm system is triggered.
