PLDVRCAM44 VEHICLE DVR DASH CAM KIT Dual Camera Video Recording System with Full HD 1080p USER MANUAL
BASIC KEY FUNCTION 1. Mode Button A: Press Mode button to switch Video / Photo /playback mode in standby; B: Short press to lock current video file while recording. 2. Up Button A: In standby, it’s used to switch between the front camera and rear camera. B: In setting menu, it’s used to select the marker. 3. OK Button Confirmation button. A: Short press to start and stop recording; Or short press to turn on screen in screen saver. B: Long press to power on and shut down 2 www.PyleUSA.
4. Down Button A: Short press to turn on/off audio recording. B: To select the marker in setting menu 5. Menu Button Short press to pull out the setting menu. Installation Guide 1. Before power on, insert micro SD card into device. Please use high speed micro SD card (Class 10 or above), capacity no less than 8GB,Maximum support card up to 32GB. 2. Install the suction cup mount and mount it near the rearview mirror (recommended) 3. Plug the original car charger into the car cigarette lighter. 4.
down after 5 seconds. Recorded files will be saved on the micro SD card. 2. Manual Recording Function Long press recorder “OK” confirmation button for 3 seconds, the camera will power on and start recording automatically. 3. Photo Taking Mode. In standby, short press Mode to enter photo taking mode, Use OK button to take a photo, and UP and Down button to zoom in and out. 4.
objects in the screen for 5 seconds, the car DVR will stop recording. If you need to exit the motion detection mode, long press “MENU” button for 3 seconds to exit in standby mode. 7. Collision Sensor Function Built-in crash sensors (G-sensor). If there is a vehicle collision, the camera will lock current video file on the accident happened 10 seconds before and after data. Also there is locked icon shown on the lower left of the screen. The locked file won’t be overwritten by loop recording.
10. Playback Short press “MODE” button in standby mode, you can enter into the playback mode. Short press “ up/down” button to find file playback. Short press “OK” to play. If you need to exit playback mode, short press “MODE” button again. 11. View Reverse Video The camera must be powered by the car charger, connect the red wire on the rear camera to the reversing light cable positive electrode.
Specification: Display: 4.0 inch IPS screen Lens: Front 130 degree Wide angle lens Lens aperture: F2.0 aperture Front camera Resolution: 1920*1080, 1280*720,848*480 Rear camera Resolution: 720*480P Loop recording: 1min, 2min, 3min, 5min,10min /off Video format: MOV Audio: built in MIC and speaker Parking monitoring: high/middle/low/OFF Motion detection: ON/OFF ISO: Auto WDR: Supported G-sensor: Supported LED light: Supported Rear Camera Mirroring Supported PC interface: USB 2.