Manualshelf

Instructions / Assembly

ManualsBrandsPyle ManualsGarden CenterPure Clean Multi-Function Portable Spray Pressure Washer Cleaning System Power Bank Flashlight and Rechargeable Battery
567891011121314
11
Storing Your Portable Washer
Your portable washer should be stored in such a way to protect it from freezing. Do not store this unit outdoors or in an
area where temperatures will fall below 0°C (32°F). This can cause extensive damage to this unit and void the warranty.
Water should not remain in the unit for long periods of time. Sediment or minerals can deposit on to the pump parts and
affect the pumping of water. If you do not plan to use the portable washer for more than 30 days, please follow these
instructions.
DRAIN WATER FROM MACHINE:
1. Turn off the switch; squeeze the nozzle lever to release pressure. Remove the nozzle and squeeze it to drain water
from the nozzle. Empty water from tank. Turn unit on and run for approximately 30 seconds without nozzle.
2. Detach the high pressure hose. Elevate one end and allow the water to drain from the hose.
3. Remove and place the hose, nozzle and power cord in the mesh storage compartments.
4. If unit must be stored in freezing conditions, or will be stored for more than 30 days, a pump winterizer/protector or a
non-toxic RV anti-freeze can be used to prevent freezing and reduce mineral deposits.
CONDITIONS FOR STORING THE POWER BANK
1. Detach the power bank from main unit, store it in a dry, cool and well-ventilated place, protect from direct exposure
to sunlight.
2. The power bank must be stored in a partial state-of-charge, ideally 50% with a recommended temperature of
0°~20°C.
3. Ideal temperature to protect the life span of the battery:
Working: 0°C ~40°C; Storage: 0°C ~40°C; Charging: 0°C ~35°C
ADD ANTI-FREEZE AS FOLLOWS:
1. Pour approximately 3 liters (1/2 gallon) of RV anti-freeze into the tank.
2. Connect the high pressure hose, nozzle, and power cord.
3. Turn the unit on and squeeze the lever until a steady stream of RV anti-freeze in present.
4. Turn the unit off. Squeeze the nozzle lever to release pressure.
5. Remove and place the hose, nozzle and power cord in the mesh storage compartments.
USING PRESSURE WASHER AFTER STORING WITH ANTI-FREEZE:
1. Drain the anti-freeze. (follow steps 1 and 2 from Drain water from system)
2. Run one tank of fresh water through the system before using to ensure that all anti-freeze is purged from system.
WARNING: USE ONLY RV ANTIFREEZE. ANY OTHER ANTI-FREEZE IS CORROSIVE AND CAN DAMAGE
YOUR PUMP AND VOID THE WARRANTY.