PDWM1950 PDWM1958B PDWM2880B PDWM1988B PDWM2850 PDWM1980 PDWM2950 PDWM2958B Compact UHF Wireless Microphone System USB Powered Desktop Mic Receiver System with Adjustable Volume Control
• To set up the system and to avoid interference, each unit may have many System Component presented channels. • When using numbers of receiversltransmitters together, each unit should use different channels. Tips 1. Transmitter and antenna should keep in a barrier-free linear relative position. 2. Do not place receiver close to metal surface object or digital equipment. 3. Try to keep receiver 1.5m above the floor and 1m away from the wall.
Receiver 6 AF 6 AF RF RF RF 5 5 POWER VOL-A AF VOL-A POWER VOL-A POWER VOL-B POWER 5 VOL-A 7 VOL-B 7 5 12 12 8888 8888 5 5 DC 5 V O UT DC 5 V I N ANT- A A U D IO O U T BALANCED-B 11 10 ANT-B 8 9 2 DC 5 V O UT DC 5 V I N ANT-A A U D IO O U T BALANCED 11 10 9 ANT- A A U D IO O U T DC 5V IN 8 10 ANT- B BALANCED-A 8 ANT-B 1. Power Switch 2. VOL. A 3. VOL. B 4. RF Signal Lamp 5. AF Signal Lamp 6. Power Signal Lamp 7. LCD Display 8.
Body Pack Transmitter (Only apply to some models) Matching Receiver and Transmitter (Only apply to some models) 1. Make sure the receiver is powered OFF. 2. On transmitter side, press and hold the frequency- change button, then press and hold the power button till the display is flashing. 3. Turn ON the receiver and then you will see the RF light is flashing. 4. Attention: For the receiver that has LED display, turn ON the receiver and wait for 3-5 seconds 5.
BODYPACK TRANSMITTER CONNECTION 1 AF RF RF 1. Lavalier Microphone Connection: Connect the connector of supplied lavalier microphone to the connecting jack of transmitter (Shown as below). Set the transmitter work state in wireless lavalier system. POWE R OFF AF VOL-A VOL-B POWER 2 3 AF RF RF AF VOL-A 8888 Fl as POWER a P O W E R ON b Flashing c b VOL-B g hin Press and hold 4 a Frequence change button Press and hold 5 W a it fo r 4~5 s e c o n d s AF RF RF 8888 B 2.
Charging the microphone (Only apply to some models) TROUBLESHOOTING CAUTION: For charging microphone, MUST NOT use AA battery to power the microphone. MUST use 14500 lithium battery. Problem No sound or sound is weak Status Transmitter display or light is off 1. Turn on transmitter 2. Make sure battery is installed right 3.
SPECIFICATION DESKTOP WIRELESS MICROPHONE SYSTEM Some specification may not apply to some models.
