Datasheet

ManualsBrandsPyle ManualsMicrophonesPDWM2700

TROUBLE SHOOTING

Please read and check the following points before asking for service.

The wireless microphone fails fo work:

--Check the microphone battery by switching the microphone ON. If power LED indicator lights red, replace the battery.

--Check the POWER indicator on the receiver unit is ON. If not, check the mains power adapter is firmly plugged into a working

mains socket.

--Check the amplifier system is ON and the microphone controls set correctly.

--Check the radio microphone jack lead is firmly connected into the output socket on the rear panel of the receiver unit and

into the MIC input socket on your amplifier.

The working range is limited:

--Check the microphone battery condition(see above)

--Check the aerials are fully extended. Adjust the position of the aerials to achieve the best reception.

--Check the settings of the microphone controls on the amplifier. Adjust volume and tone to get the beat sound without any

trace of feedback.

www.pyleaudio.com

USER'S MANUAL

TWO CHANNELS VHF WIRELESS MICROPHONE

PDWM2700

MIN MAX

AUDI O

POWE R

SIGN AL -A

P R OF ES SI ON AL

PD W M2 7 00

W I R EL ES S M I C RO PH O NE

SIGN AL -A

AUDI O

VHF

OPEN

Summary of content (4 pages)

PAGE 1
TROUBLE SHOOTING R PDWM2700 Please read and check the following points before asking for service. The wireless microphone fails fo work: --Check the microphone battery by switching the microphone ON. If power LED indicator lights red, replace the battery. --Check the POWER indicator on the receiver unit is ON. If not, check the mains power adapter is firmly plugged into a working mains socket. --Check the amplifier system is ON and the microphone controls set correctly.
PAGE 2
Thank you for choosing our VHF wireless microphone system. We strongly suggest that you carefully study these instructions before attempting to operate the system. SPECIFICATIONS CONTENTS A.Overall system P1--------Precautions P2--------Handheld microphone P3--------Body pack transmitter P4--------Receiver P5--------Instalation P6--------Specifications P7--------Troubleshooting PRECAUTIONS 1.Avoid exposure of the system to rain or moisture. 2.No user-serviceable parts inside the system.
PAGE 3
INSTALLATION HANDHELD MICROPHONE UNSCREW BATTERY COVER TO INSERT BATTERY AMPLIFIER SPEAKERS MIX ANT.B BALANCED DC 12V AF.OUT ANT.A BATTERY CONDITION INDICATOR RADIO MIC RECEIVER UNIT POWER SWITCH POWER COVER MAINS POWER ADAPTER To connect the wireless microphone to your amplifier system: 1.Unscrew the battery cover at the end of the microphone. Install the provided 9 volt battery and then close the cover. Make sure to connect with the correct polarity. 2.Move power switch to ON position.
PAGE 4
BODYPACK TRANSMITTER BODYPACK TRANSMITTER VOLUME CONTROL (HIGH/LOW) ON/OFF LED MIC IN R BATTERY COVER OPEN PROFESSIONAL WIRELESS MICROPHONE MIN MAX OPEN OPEN CLOSE 9V BATTERY Headset MIC SIGNAL-A AUDIO POWER MIX ANT.B BALANCED VHF PDWM2700 SIGNAL-A AUDIO MIN MAX DC 12V AF.OUT ANT.A Lavalier MIC(Optional) 1.Slide up the battery cover in the front of the body pack as per above sketch map. Install the provided 9 volt battery and the battery cover.