PDWM3360 PDWM3365 PDWM3360 - PDWM3365 Wireless Microphone System
CATALOG 1. FOREWORD --------------------------------------------------------------------------------------------- 3. SYSTEM FEATURES 4. SYSTEM TYPE 2 ----------------------------------------------------------------------------------- 2 ------------------------------------------------------------------------------------------- 2 5. DUAL CHANNEL RECEIVER FEATURES 6. TRANSMITTER FUNCTION & FEATURES 7. TRANSMITTER BATTERY INSTALLATION --------------------------------------------------- 10.
DUAL CHANNEL RECEIVER FEATURES 1. Power Switch: Power ON/OFF the receiver. 2. Power Indicator: Indicate the power ON/OFF. 3. "RF" Signal Indicator: It glows when the Receiver receives RF signal from Transmitter. 4. "AF" Audio Level Indicator: Indicate the wireless system audio signal level. 5. LCD Information Display: Shows the receiver frequency channel etc. 6. Down Function Button: Sets channel data. 7. Up Function Button: Sets channel data. 8. Volume Knob: Adjust the volume output of receiver. 9.
1. Power and Audio Mute Switch. 2. Antenna: Transmit the RF signalof transmitter. 3. Belt Clip: Attach the transmitter to the belt. 4. Audio Input Jack: it is suitable for lavaliere system/headset system. 5. Low Battery Indicator: Red light glows when it is lack of power and should renew the battery. 6. LCD Information Display: Show the transmitter frequency channel etc. 7. Gain Adjusting Volume: Adjust the transmitter audio input gain. 8.
TRANSMITTER BATTERY INSTALLATION 1. Transmitter Battery Installation: Push open the battery cover, insert the supplied batteries into battery jar matching polarity and cover the battery. TROUBLESHOOTING PROBLEM No Sound 7 If the battery is inserted properly, replace with fresh battery.
SYSTEM SPECIFICATIONS HAND-HELD TRANSMITTER SPECIFICATIONS • RF Carrier Frequency Range: Approximately 523 to 597.8 MHZ (Available frequencies depend on applicable regulations in country where system is used). • Operating Range: 50m (approximately 164ft) under typical conditions • Audio Frequency Response: 100 to 18,000Hz, ±3dB • THD: <1% • Mobile state Range: > 100dB Power Requirements 1.