User Manual

3 4
1. Grille: Protects the cartridge and help
reducing the breath sounds and wind
noise.
2. LCD Information Display: Show the
transmitter frequency channel ect.
3.Down Function Button: Sets channel data.
4.Up Function Button: Sets channel data.
5.Power and Audio Mute Switch.
6.Battery Cover: Open it to install the battery.
1
4
5
2
3
6
EIGHT CHANNEL RECEIVER FEATURES
Front Panel
Rear Panel
1
8
42 53 42 53 42 53 42 53
6 7 6 7 6 7 6 7
8 9 10 810 10 10 11 11 1210 10 10 10
1.Power Button: Power ON/OFF the receiver.
2.Down Function Button: Sets channel data.
3."RF" signal Indicator:It glows when the Receiver receive RF signal from
Transmitter.
4.LCD Information Display: Show the receiver frequency channel ect.
5.Volume Knob: Adjust the volume output of receiver.
6.Up Function Button: Sets channel data.
7."AF"Audio Level Indicator: Indicate the wireless system audio signal level.
8.Antenna.
9.Power switch of CH5-8:
When switch to "ON" position, it means CH5 to CH8 is on, all channcels from
1 to 8 is on for working.
When switch to "OFF" position, it means CH5 to CH8 is off, only CH1 to CH4
is on for working.
10.XLR Balanced Output Jack: Connect the audio cable from this jack to
the input port of amplifier, mixer.
11.1/4" Audio Output Jack: Connect the audio cable from this jack to the
input port of amplifier, mixer.(CH1-4 or CH5-8)
12. Power Jack: Connect the AC/DC adapter to receiver.
CH1
CH2
CH3
CH4
CH5
CH6
CH7
CH8
UHF
PLL
EIGHT CHANNEL
PROFESSIONAL
WIRELESSRECEIVER
ANTENNA
B
CH 5-8
CH 1-4
BALANCED OUTPUTS
CH - 5CH - 6CH - 7CH - 8
BALANCED OUTPUTS
CH - 1CH - 2CH - 3CH - 4
MIX OUT
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
UHF
Tested to Comply
With FCC
Standards
FOR HOME OR OFFICE USE
ANTENNA
A
1. Power and Audio Mute Switch.
2. Antenna: Transmit the RF signal of transmitter.
3. Belt Clip: Attach the transmitter to the belt.
4. Audio Input Jack: it is suitable for lavalier system/headset system.
5. Low Battery Indicator: Red light glows when it is lack of power and should
renew the battery.
6. LCD Information Display: Show the transmitter frequency channel ect.
7. Gain Adjusting Volume: Adjust the transmitter audio input gain.
8.State Setting Switch: Set the using state of lavalier system(L)/headset
system(H)
9.Up Function Button: Sets channel data.
10.Down Function Button: Sets channel data.
/guitar system(G).
14 5 2
3
7 8
6
9 10
BELT-PACK
TRANSMITTER
DISPLAY