Owner`s manual

GENERAL OPERATION
• SWITCHING ON/OFF THE UNIT
Switch on the unit by pressing any
button (except
EJECT button (7)).
When system is on, press
POWER
button (1) to turn off the unit.
• SOUND ADJUSTMENT
Press SEL button (2) shortly to select
the desired adjustment mode.
The adjustment mode will change in
the following order:
By rotating the audio knob (2)
clockwise or counter-clockwise, it is
possible to adjust the desired sound
quality.
Press and hold the SEL button (2) for
several seconds to adjust beep
options, Rotate the audio knob (2)
clockwise or counter-clockwise to
select as follows:
- BEEP 2’nd mode:
The beep is only generated when
double key is pressed for (1 sec).
e.g.
When preset button (17) is pressed.
When BND(LOU) button (11) is
pressed. When AS/PS(D-AUD)
button (25) is pressed.
- BEEP ALL mode:
The beep is generated when any key
is pressed.
- BEEP OFF mode:
The beep is disabled.
LOUDNESS
Press BND/LOU/ENT button (11) for
several seconds to reinforce the bass
output. Press it for several seconds again
to release this function.
MUTE
Press MUT button (23) to mute the sound
instantly. Press any button to get out of
mute mode.
EQUALIZATION
Press EQ button (5) to turn on equalization
function and to select desired audio mode.
There are five kinds of modes as shown
below:
SUBWOOFER
Press MOD button (12) for several
seconds to toggle sub-woofer output.
Press it for several seconds again to
release this mode.
LIQUID CRYSTAL DISPLAY
Exhibits current frequency and activated
functions on the display (4).
REMOTE SENSOR
Point the remote control handset to the
remote sensor IR (6). Press the function
keys on the handset to control the system.
ESP FUNCTION
If the unit has the electronic shockproof
function, it can be shockproof for several
seconds.
AUXILIARY INPUT
The unit can be connected to a portable
audio player through the AUX IN jack (8)
on the front panel. After finishing the
connection, you can press MOD button
(12) on the front panel to switch the mode
to AUX IN mode.
RESET FUNCTION
RESET button (24) must be activated with
either a ballpoint pen or thin metal object.
The RESET button is to be activated for
the following reasons:
- Initial installation of the unit when all
wiring is completed.
- All the function buttons do not operate.
- Error symbol on the display.
Note: If pressing the RESET button (24)
does not work, please use a cotton swab
soaked in isopropyl alcohol to clean the
socket on the front panel.
8
OPERATION
VOL BAS TRE BAL FAD
(Volume) (Bass) (Treble) (Balance) (Fader)
FLAT CLASSICS POP M ROCK M DSP OFF
BEEP 2ND BEEP ALL BEEP OFF