User Manual

System Installation and Wiring
Note: Camera System installation on diesel vehicles may require a slightly different wiring install -- or possibly may not even be
compatible.
Quick Installation:
This rearview backup camera system comes in two parts, one is the camera, the other is the monitor. When
installing, the camera can be mounted in the rear of your vehicle (preferably just above the license plate).
This kit includes necessary wiring and cable connector accessories sufficient for typical connections.
However, additional accessory cables and installation materials may be necessary for a completely
secure and operational backup camera performance.
Camera Connection:
Connect the camera, using the red wire, of the included DC 12V power cable, to the positive 12V reverse tail
light in the rear of your car. Then, connect the black wire, of the DC 12V power cable, making sure to ground
properly. This connected power and ground cable then connects to the camera, and will supply power to the
camera directly.
Next, use the included yellow RCA video connector cable, and run that cable from the yellow RCA video
connector jack of the camera, to the yellow video connector of the included display monitor.
Display Monitor Connection:
Connect the monitor, using the red wire, of the other included DC 12V power cable. Connect this wire to your
vehicle's fuse panel to provide power to the monitor. Then connect the black wire of the DC 12V cable making
sure the connecting is grounded properly.
The additional video input on the monitor (white cable connector) is available for connecting an additional
monitor or display screen. The included display monitor assembly, when connected, automatically retrieves the
video signal when activated.
Caution: Connecting to other types of electrical systems will cause damage to your vehicle. Please contact the manufacturer if you are
unaware of the system type in your vehicle. Refer to the model's power requirements prior to connection and installation.