User Manual

1. Set the mount stand in the desired location, then use screws to secure the
mount stand into location. Please make sure as to set a location free from
vehicle obstruction including any wiring, or location where it may obstruct
the driver's view, driving conditions, etc.
2. Attach the metal buckle piece on top of the fan shaped mount stand, and slide
it into the receiving slot in back of the display monitor assembly. This metal
buckle should slide in and up to the monitor assembly.
3. Set the desired position/height of the buckle into the monitor assembly.
4. Tighten the clamp-style knob in the back of the stand mount to secure the
monitor in the desired position.
5. The angle / tilt position of the stand mount is also adjustable. Located toward
the base of the stand mount is another clamp-style knob.
If you are experiencing any problems with your
camera and monitor system please contact:
[e-mail]
Pyle Service Center
1600 63rd St.
Brooklyn, NY I 1204
www.PyleUSA.com