User Manual

www.PyleUSA.com

CHARGING THE BATTERY

Charge the device by connecting the camera via the USB car

charger port. Use only PLDVRCAM74 approved chargers.

Using unapproved chargers or cables can damage the device

or cause the battery to explode.

Connect the car charger’s jack to the USB charging port, and

then plug the charger into the car cigarette lighter or 12V DC

power outlet.

• Battery is mainly used to save les in emergency. Please

always connect dash cam to external power while it is in use.

• When device detects no power supply, it will automatically

power o after 5 seconds. To turn on the device again, you

will need to do so manually by pressing the ON / OFF button.

• If the battery is completely discharged, the device will not

turn on immediately when the charger is connected.

Allow a depleted battery to charge for a few minutes before

attempting to turn on the device.

• The device can be used while it is charging, although it may

take longer to fully charge the battery.

• If the device receives an unstable power supply while

charging, the screen may not function properly. If this

happens, unplug the charger from the device.

• While charging, the device may heat up. This is normal and

should not aect the device’s performance or lifespan.

• If the device is not charging properly, take the device and

the charger to an authorized Service Center.

Connecting the charger improperly may cause serious

damage to the device. Any damage caused by misuse is not

covered by the warranty.