Always on the watch...
TRANSMITTER ICONS Button 1 or Button 2 IMPORTANT NOTICE t Please have system installed by an authorized dealer. t Protect this product and its transmitters from humidity and water. t Read manual carefully before installing and operating the unit. t Replace battery when the transmitter's operating distance is shortened or its indicator lights dim noticeably.
FUNCTIONS ARMING OPERATION To arm the system press transmitter button 1: t The siren will chirp once. once.* t The parking lights will t The LED will rapidly then start slowly. After 8 seconds the system is armed (2-way only). While armed, the system will trigger if: t If alarm detects a light impact, siren chirp, and 3 times to warn away a potential intrudlights er. When triggered a second time in 15 seconds, for the siren will sound and parking lights will 15 seconds, Ignition Disable will be engaged.
FUNCTIONS tion of system operations and status. After a function such as arming is selected, the LCD display will show confirming icons to indicate that the function has taken place. The LCD display shows any intrusion attempts as they occur. In addition to LCD display, the 2-way transmitter also provides audible and vibration alert in case the display is out of view. For nighttime use the LCD is equipped with a backlight feature.
FUNCTIONS relay. Connect to the motorcycle turn signal wires. If the motorcycle’s turn signal circuit exceeds 10 Amps a relay is required. NOTE: Do not connect the YELLOW wire’s to the Motorcycle’s headlight circuit. t Orange WIRE - +12V Ignition input. Connect to a main ignition wire at the ignition switch harness. This wire shows +12V when the ignition is on and while cranking. The voltage must not drop when the motorcycle is starting.
PLMCWD15/PLMCWD25/PLMCWD75 – INSTALLATION DIAGRAM 7
ECU INSTALLATION IGNITION DEFEAT WIRE DIAGRAM Please mount the ECU downside as shown in the figure. +12V IGNITION (MOTOR SIDE) TO GREY IGNITION DEFEAT WIRE ON ECU 86 87 85 87a 30 +12V IGNITION (KEY SIDE) SIREN INSTALLATION LED INSTALLATION Mount the siren downward as shown in figures 1 or 2 below. 1 2 1. Drill a hole (Ø8mm) around the block where it can be seen clearly. 2. Insert the outer bushing to the hole. 3. insert the inner bushing with LED to the outer bushing and tighten them up. 4.
TROUBLESHOOTING 1). Transmitter is ineffective or the control distance decreased significantly. t Tall building, radio tower or high frequency electromagnetic wave may affect the control range. t Low power of the battery. t The transmitter is broken or damaged. t The installation location of the antenna is wrong. You should straighten the antenna and keep it away from other wire harness. 2). The siren does not chirp when the alarm system is triggered.
NOTES 10
Always on the watch...
PLCWD_2Way_Manuals.qxd 06/03/14 www.pyleaudio.
