User Guide

Elite Series Waterproof Amplifiers
Mono Input Connection - RCA Type
Select Elite Series Amps may easily be bridged for mono operation by feeding the
same signal to both LEF T and RIGHT Input terminals. The simplest way to achieve
this is by using a Y-adaptor to connecting your car stereo output.
Speaker Connection - Stereo Amp System
Connect the output terminals to the corresponding LEFT and RIGHT Speakers.
(Fig. 1 below shows a pair of speakers connected in stereo)
Speaker Connection - Mono Amp System
Select Elite Series Amps may be bridgeable from a 2 channel amplifier to a one channel
amplifier. The ideal speaker impedance for optimum operation is 4 ohms. The amplifier
will provide stable operation when operated between 2 and 8 ohms loads. The minimum
recommended speaker load is 2 ohms for each channel in normal operation. When
operating in the bridged mode the minimum recommended speaker load is 4 ohms for
each bridged channel. Operation of the amplifier below this impedance load can damage
both the amplifier and your speaker and will void your warranty.
Stereo Amp Connection
Mono Amp Connection
2-8 Ohm
4-8 Ohm