User Manual

• Consult local laws and regulations for any restrictions on installation or use.

• Using a Backup Camera System is not adequate enough to completely eliminate a

vehicle’s blind spot. Always remember to drive with caution, following all trac laws.

System Installation and Wiring

Note: Camera System installation on diesel vehicles may require a slightly dierent

wiring install.

Caution: Connecting to other types of electrical systems will cause damage to your

vehicle. Please contact the manufacturer if you are unaware of the system type in your

vehicle. Refer to the model's power requirements prior to connection and installation.

Quick Installation

This rearview backup camera system comes with camera and installation wiring.

When installing, the camera is preferably to be mounted in the rear of your vehicle

(just above the license plate).

This kit includes necessary wiring and cable connector accessories sucient for typical

connections. However, additional accessory cables and installation materials may be

necessary for completely secure and operational backup camera performance.

Camera Connection

Connect the camera to the using the included DC 12V power cable. Connect the DC

12V power cable to the positive 12V reverse tail light in the rear of your vehicle.

Then, connect the black wire, of the DC 12V power cable, and ground properly.

This connected power and ground cable then connects to the camera, and will supply

power to the camera directly.

Next, use the included yellow RCA video connector cable, and run that cable from the

yellow RCA video connector jack of the camera, to the yellow video connector of your

compatible display monitor.

The yellow RCA cable when connected, automatically retrieves the video signal when

activated (when your vehicle is switched into the reverse gear).

Installation Transcript

1. Locate the reverse taillight wiring behind your vehicle's reverse light.

You may need to remove an interior panel, or other cover, in order to locate the

wiring. Connect the included power 12V DC power cable to the reverse light.

a. Connect the power cable's Red wire to your vehicle's reverse light positive wire.

b. Connect the power cable's Black wire to your vehicle's reverse light negative wire.

2. Connect the camera to this 'reverse light' connection installation, then mount the

camera in the desired location.

3. Run the RCA video cable from the camera to your compatible video displa monitor.