PLUTV42CH 800W Waterproof Marine Speakers + 2 Ch.
PRECAUTIONS • This unit is designed for negative ground 12-14.50 Volts (DC) operation only. • Use speakers with an impedance of 4 Ohms • Avoid installing the unit where: • It would be subject to high temperatures, such as from direct sunlight or hot air from the heater. • It would be exposed to rain or moisture. • It would be subject to dust or dirt.
REMOTE TURN-ON CONNECTION The amplifier is turned on by applying +12V to the remote turn-on terminal (REM). The wire lead to this terminal should be connected to the "Auto-Antenna" lead from the vehicle/or boat stereo resources which will provide the +12V only when the stereo resources is turned on . If the car stereo does not provide an "Auto-Antenna" lead, the remote turn-on lead may be wired to an "Accessory" or "Radio" terminal in the vehicle’s/or boat’s fuse block.
+ 12V = POWER SUPPLY Connect the BATT terminal to the positive pole of the battery with a lead cable and add a fuse into the power cable in a distance of not more than 30 cm from the battery. The lead cable’s diameter should be at least 4 mm’ for a length of 3m and 6mm” for a length of 6m. REM (ON/OFF) REMOTE CONTROL Connect the REM terminal to the automatic antenna connector of your vehicle/or boat radio.
NOTES ON THE POWER SUPPLY • Connect the +12V power input lead only after all other leads have been connected. • Be sure to connect the ground wire of the unit securely to a metal part of the vehicle/or boat. • Loose or faulty connection may cause amplifier malfunction • REM: The unit is turned on by applying +12 Volts to this terminal. This terminal does not draw heavy current like the tow Power Terminals so a thinner connecting wire is acceptable. Standard 18 GAUGE is fine and the standard color is red.
No Sound: • Speaker cable or speaker plug are not connected correctly. • The plus and minus wires of the speaker cable have contact, thus eliminate the short circuit. If you use Pay attention only 4 ohm load speaker is allowed. No 2 ohm or less impedance speaker connection is allowed. Poor Sound Quality (Distortions): • The speakers are overloaded, therefore turn down the volume level and check the volume control positions.
• To reduce contact resistance and bad and loose contacts, please solder the cable ends or use multi core cable ends, spade terminals or others. Gold Plated spade terminal are free of corrosion and have the lowest contact resistance. • Should all these meaures be without any success, the use of a ground loop isolator may solve the problem. PLUTV42CH Speaker Installation Speaker Mounting suggestion as below: Rubber Pad Auto Reconnection: Step 1: Unbolting the mounting bracket.
Step 5: Use Butt Connector accessories to Connect Speaker wires (See Illustration 1,2,3).
Technical Specs: • Amplifier Type: 2-Ch. Audio Component • Power Output: 800 Watt MAX • 2 x 45 Watts RMS @ 4 Ohm • Marine Grade IP-65 Rating • T.H.D: 0.1% • S/N Ratio: > 93dB • Channel Separation: > 50dB • Frequency Response: 20Hz-20kHz • Fuse: 15A • Power: DC 12V • Amp Dimensions (L x W x H): 5.3’’ x 3.5’’ x 2.1’’ -inches Marine Speakers: • Pro Audio PowerSport Speakers • Sound System: (2) x 4”Woofers + (2) x 0.
Questions? Issues? We are here to help! Phone: (1) 718-535-1800 Email: support@pyleusa.
