User Manual

www.PyleUSA.com
7
Gold Plated spade terminal are free of corrosion and have the lowest contact
resistance.
• Should all these meaures be without any success, the use of a ground loop
isolator may solve the problem.
PLUTV60CH Speaker Installation
Speaker Mounting suggestion as below:
Step 1: Removing the top half of clamp
Put the PLUTV60CH speaker in a safe place.
Using the 1/4” Hex key, remove the top clamp bolts.
Step 2/3: To adjust mounting clamp angle and speaker position
Diagram A is to show there are four round pins underneath the bottom
base of aluminum die cast clamp, which can be inserted and xed to four
round notch holes on top of plastic cabinet as diagram B shows by every
45 degrees adjustment either at clockwise or counter clockwise direction.
Through such design, user can change the angle of swivel clamp, use the
5/16” hex key to loose the center screw a little bit and lift the bottom clamp
to twist speaker angle by every 45 degrees to get the optimal angle you
want. Then re-making sure the pins on base of bottom clamp are inserted
and sits on notch holes on top of plastic cabinet at and seamlessly.
Then re-tighten the center hex screw to secure the bottom clamp strongly.
5/16”
Hex key
1/4”
Hex key
45°
Diagram A
Diagram B