User Guide
Multi-Channel Mixers
PyleUSA.com
Warnings
Please be sure to read, keep and refer to instructions listed in this manual.
Do not use this device near water or expose to moisture.
Clean only with a dry cloth.
Do not block any ventilation openings and allow adequate space for air flow during operation.
Do not install near any heat sources or other devices that produce heat.
Do not defeat the safety purpose of the polarized or grounding-type plug.
Protect the power cord from any kind of damage or corrosion.
Unplug the mixer when not in use or when unused for long periods of time.
Refer all service to qualified service personnel. Servicing is required when the mixer has been damaged or performs in an unusually.
Use only speaker cables when connecting speakers to amplifier outputs. Using other types of cables is a fire hazard.
Exposure to extremely high noise levels may cause in permanent hearing loss. Individuals vary considerably to noise induced hearing loss but
take precaution when listening at high levels.
If the power cord is damaged (i.e., cut or a bare wire is exposed), ask your dealer for a replacement. Using the unit with a damaged power cord
is a fire and electrical shock hazard.
Should this unit be dropped or the cabinet be damaged, turn the power switch off, remove the power plug from the AC outlet, and contact your
dealer. If you continue using the unit without heeding this instruction, fire or electrical shock may result.
CAUTION
If the unit is damaged or non-operational, please notify your dealer and the shipping company immediately. Claims for
damage or replacement may not be granted if not reported properly or in a timely manner.
Connect this unit’s power cord only to an AC outlet of the type stated in this Manual or as marked on the unit. Failure to do so may result in
fire and/or electrical shock.
Do not place heavy objects on top of the power cord. A damaged power cord is also a fire and electrical shock hazard.
Use only the included power cord for this unit, using other types may again result in fire and electrical shock.
Do not set all equalizer controls and faders to maximum levels. Doing so may cause oscillation depending on the condition of the connected
unit and speakers, and may also damage the speakers.
The performance of components on this mixer such as switches, rotary controls, faders, and connectors, deteriorates over time. The rate
depends on the operating environment and is sometimes unavoidable. Consult your dealer about replacing defective components.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT ATTEMPT TO OPEN OR ACCESS THE INSIDE OF
THE UNIT. REFER ALL SERVICING TO A QUALIFIED PYLE
SERVICE PERSONNEL.
This lightning flash symbol is intended to alert the user to the presence of uninsulated and “dangerous
voltage” within the mixer's enclosure that may be of sufficient power to constitute a risk of electric shock.
This exclamation point symbol is intended to alert the user to the presence of important operating
and maintaining instructions, that one should pay attention to and keep for future reference.