PNVR300 PNVR450 PNVR800 OWNER'S MANUAL POWER INVERTER PNVR300 150WATT PNVR450 220WATT PNVR800 400WATT www.pyleaudio.
INTRODUCTION Thank you for purchasing the PYLE DC to AC Power Inverter. The PNVR300/PNVR450/PNVR800 will deliver an efficient power to a wide variety of household AC products or electronic appliance reliably from the 12 volt outlet in your vehicle or boat, or directly from a 12 Volt battery to serve such as mostTVs, VCRs, Play Stations, Work Lights, Soldering Irons, etc. Please pay your special attention to all CAUTION and WARNING statements.
FEATURES PNVR300/PNVR450/PNVR800 1.AC OUTLET 2. ON/OFF SWITCH 3. POWER ON LED 4. PROTECTION LED 5.
OPERATION • CAUTION: DO NOT USE THIS INVERTER WITH THE FOLLOWING: • Small battery operated appliances such as RECHARGEABLE FLASHLIGHTS,SOME RECHARGEABLE SHAVERS and NIGHT LIGHTS that are plugged directly into as RECEPTACLE TO RECHARGE • BATIERY CHARGERS used with certain power tool battery pecks. These chargers will have a WARNING LABEL stating that DANGEROUS VOLTAGE ARE PRESENT AT THE CHARGERS BATIERY TERMINALS. -WARNING: Batteries contain corrosive materials and present an Energy Hazard.
-The LED indicators A. GREEN: It indicates the inverter is power on, the cooling fan (PNVR300IPNVR450/PNVRBOO) is also activated, and AC power will be delivered to the AC outlet. B. RED: It indicates the inverter shut down caused by low voltage, overload, or excessive temperature. -The ONIOFF switch It enables output AC power at the AC outlet when switched ON. It also acts as a manual reset for overload, low battery voltage and overheat fault conditions.
BATTERY OPERATING TIME The operating time of battery will vary depending on the charge level of the battery, its capacity and the power level drawn by the particular AC load. The vehicle batteries are not intended for constant deep discharge, they are designed to provide brief periods of very high current needed for engine starting. It is strongly recommended to start the vehicle every hour or two to recharge battery before its capacity drops too low.
TROUBLE SHOOTING SYMPTOM A: NO AC POWER OUTPUT, THE RED LED LIGHTS. POSSIBLE CAUSES SUGGESTION The connected AC products are rated at more than 150 Watts Use the product with a total power rating (PNVR300) , 220 Watts (PNVR450) or 400 Watts (PNVRBOO), less than t50 Watts (PNVR300), 220 Watts the overload shutdown occurred. (PNVR450) and 400 Watts (PNVRBOO).
SYMPTOM C: THE LOW OUTPUT OF INVERTER IS MEASURED POSSIBLE CAUSES SUGGESTION BaHery voltage is too low below 10V DC Recharge battery The inverter is overload Reduce load to t 50 Watts (PNVR300) , 220 Watts (PNVR450) and 400 Watts (PNVR800) maximum to maintain regulation. SYMPTOM D: THE LOW BATTERY IS MEASURED POSSIBLE CAUSES SUGGESTION The poor battery condition Recharge battery Inadequate power of excessive voltage drop Check condition of battery clips and terminals.
SPECIFICATIONS AC output voltage (nominal)·· .. •·· .. ·· .. •· .. •·· .. •· .. ••· .. • ... •·· .. •· 115 Volts AC DC input voltage range· .............................................. 10-15 Volts DC Maximum Continuous AC output power· ............................... ·150 Watts (PNVR300) · .................................................................. 220 Watts (PNVR450) · .................................................................. 400 Watts (PNVR800) Maximum AC output surge power· ..••••.••..
