manual
It
is important that you also perfonn the calibration for
walking, as described in the following sectio
n:
•
You
can choose bet\veen YES and NO with the C
button. Choose YES and confinn with the A
button.
, Display SET CALI DISTANCE appears, choose with the
C button (0.1
to
1.0 km possible), confirm with
the A button.
• Display
PR
E
SS
SET TO START appears, start with
A button.
Now walk the chosen distance (the display PRESS TO END
appears) and press the A button afterwards.
• Display CALI OKI and SAVED appears. The calibration
was correct and was saved.
• Finally press the 0 button, the watch changes to the
initial position (display
of
current speed and lower and upper
limits for the speed).
Calibration
not
Succe
ssful
.
In case the calibration was not successful, the display CA
LI
FAILED appears. After a few seconds the display CA
LI
FOR
RUNN
IN
G
or
WALKING appears again and you can start a
new calibratio
n.
Stop
Calibration
Press the 0 button during calibration in case you want to stop
the calibration. The display CA
LI
CANCEL appears. The
watch automatically changes to the initial position (display
of
current speed and lower and upper limits for the speed). You
can now start a new calibrati
on.
Number
of
Steps
Press the C button in the pedometer mode until STEP is
displayed.
The number
of
steps is
shOwn
in
the lo
wer
segment
of
the
display, in t
he
middle the current speed.
_ "
"'0
,,-
~
3'~m/h
Number
of
steps
-'..,...-
~
81
•
Keep the A button pressed - the display RESET
appears-
reset the number
of
steps to zero.