User Guide

2. LISTEN TO FM RADIO
Connect the supplied 3.5mm audio cable to FM ANT jack on the rear of the unit
as the figure below. Extend the wire and relocate it to get the best reception.
1. Power On the unit ad previous procedures.
2. Press the INPUT button on the unit or remote control repeatedly until FM
frequency appears on the display.
3. Press or button on the remote control repeatedly to search the
specific radio stations. (To search the radio stations in auto mode. Press and
hold or button two seconds then release the button. The unit will
auto search the next available radio station then stop. Repeat above procedure
to search all available radio stations.)
4. To store the current received radio station into the memory. Press the
MEMORY button on the remote control, CH01 will appear on the
display. Press the CH+/CH- buttons repeatedly to select channel number as
desired. Press the MEMORY button again to stored the current radio station
to the selected channel.
5. Listen the preset channels; press the CH+/CH- buttons on the remote control
repeatedly until the desired channel appears on the display.
6. Press the EQ button on the remote control repeatedly to select stereo or mono
ad desired .STEREO or MONO will appear on the display.
7. Press the SCAN button on the remote control to auto search the working radio
station and auto store in memory then press CH+/CH- to choose the desired
radio station.