PTEDK50 Electronic Drum Kit Compact Drumming Machine, MIDI Computer Connection, Quick Setup Roll-Up Design (Mac & PC Compatible)
CONGRATULATIONS! Thank you for purchasing this digital drum set. The drum set has been developed to act and play like a drum set but with greater ease. Before you use the instrument, we recommend you to read through this manual. Location • To avoid deformation, discoloration, or more serious damage, do not expose the unit to direct sunlight, high temperature sources, or excessive humidity. • Direct sunlight. • High temperature (near a heat source, or in car during the day time).
ASSEMBLY INSTRUCTIONS CAUTION! Watch your fingers when adjusting clamps, they may become pinched resulting in injury. Be careful of metal pieces, pipe ends and screws. Please install in the specified order and make sure that all parts are installed in the correct position. INSIDE THIS PACKAGE Before assembly, please make sure that all the items listed below are present.
ASSEMBLY 1. Loosen frame bracket bolts with supplied drum key, and open the drum stand as shown below. Tighten bolts to secure once the stand is set into the position pictured. (Do not over tighten) 2. Loosen pad bracket bolts and insert pads and module as shown below, tighten bolts to secure. (Do not over tighten) Remove cymbal top nut and lower cymbal onto holder, re-install nut to secure cymbal. CRASH RIDE TOM1 TOM2 HI- HAT TOM3 PTEDK50 SNARE 4 www.PyleUSA.
CONNECT Connect the drum cables to the correct parts. Secure the D-SUB plug to the rear of the module with the 2 attached bolts. The Contoller pedals are placed on the floor and connected to the 'HH CTRL' (left) and 'KICK' (right) cable for your bass drum sound and HiHat control. Precautions When connecting or disconnecting cables on the module, please make sure the power switch is set to 'OFF' position to avoid damage to the module. FUNCTION BUTTON DESCRIPTION FRONT PANEL 1.
TOP PANEL 10. PHONE: Stereo headphone connector. 11. AUX IN: External stereo input connection, e.g. MP3 or CD player. 12. OUTPUT: The stereo output connector to connect with audio system or drum amp, mono output. 13. MIDI OUT: Connects with external MIDI devices (The drum MIDI signal outputs via MIDI OUT to external audio source.) 14. DC IN: Power adapter connector. 15. ON/OFF: Switches the power on and off. REAR PANEL 16. Trigger in connector: D-SUB pad signal input connector. 6 www.PyleUSA.
CONNECT WITH EXTERNAL DEVICES Connecting with audio system or drum amplifier Connect Drum Kit OUTPUT socket to audio system or drum amplifier using 1/4" jack instrument cable. Note: The volume is controlled by the Drum Kit volume knob and device volume knob. Connect with Headphones Connect headphones with 1/8" stereo connector, to the headphone socket on the Drum Kit. The volume is controlled by the Volume knob on the Drum Kit. www.PyleUSA.
Connect with MP3 or CD player Connect the output of your MP3 or CD player with the INPUT socket on the Drum Kit. Volume of input can be adjusted via your MP3 or CD player. Connect with PC Connect PC via MIDI port MIDI OUT: Delivers pad signal to PC. 8 www.PyleUSA.
Power Supply 1. Turn off the Drum Kit power switch. 2. Connect the power supply with DC IN connector. 3. Confirm all the pads are correctly connected. Set the Drum Kit volume to minimum, then turn ON the power switch of the Drum Kit. The display lights up and it enters into the drum kit menu. Turn off the power switch before connecting with other devices. OPERATION Adjust the master volume Strike the pads and adjust the volume knob for suitable master volume. Preset drum kit: KIT01--10 1.
3. In drum kit mode, LED shows the current drum kit number, press [+/-] button to switch the drum kit and select any drum kit as current drum kit. VOICE The Drum Kit has 108 voices, including the GM voices. 1. Select voice you are playing. This change will automatically save until the Drum Kit is switched off. To permanently save this setting to a user drum kit please refer to the “Saving Adjustments” page. 2. Adjust voice volume 10 www.PyleUSA.
1. In voice mode, press [Page] button to enter the voice volume adjustment (the screen will show [L- -]). Press [+/-] button to adjust the voice volume of the pad you are playing (range 0-32) 2. This change will automatically save until the Drum Kit is switched off. To permanently save this setting to a user drum kit please refer to the “Saving Adjustments”. 3. Adjust Voice Pan 1. In voice mode, press [Page] button again to enter the voice pan adjustment (the screen will show [P- -]). 2.
To recall your user kit upon next use, use [+/-] buttons to select U01 or U02. To make further adjustments to your preset kits, follow the steps above. Note: If you do not wish to save your settings after entering into save mode, press any button other than [SETUP] and [+/-] to exit save mode. SONG SETTING 1. Selecting a Song 1. Press [SET UP] button to enter into song menu, the SONG LED lights up. 2. Press [+/-] button to switch the song, range 001-010 (non-cycle); 12 www.PyleUSA.
2. Song Playing 1. Press [START/STOP] button to play the selected song. During playing, change the song via [+/-] button. The overall volume is controlled by the module volume knob; 2. Before song mode, directly press [START/STOP] button to play the song; 3. After playing,songs will stop automatically; during playing, press [START/STOP] once again to stop playing. 3. Accompaniment Volume: During playing, user can adjust the volume of accompaniment and the drum sound. 1.
METRONOME This module has 1 click voice. 1. Metronome function switch Press [CLICK] button to open or close metronome function, after [CLICK] is pressed down, CLICK LED will light on, the three LED shows the “beats”, e.g. 4-4, press [+/-] button to switch “beats”. Note: During playing the songs, the metronome is closed. 2.
Note: 1. During recording, the metronome function will not automatically start. If user needs to start the metronome function, user can press [CLICK] button before recording instead of pressing it attar recording. 2. The metronome sound can not be recorded. 3. If user is not satisfied with the recorded result, press [RECORD] to restart recording. Note: This Drum Kit supports the recording function, but not saving function.
CONNECT WITH EXTERNAL AUDIO SOURCE EQUIPMENT This equipment can send its various information via channel10, including: trigger notes, force, hi-halpedal performance and status, etc. Note: The song replaying and metronome information can not be sent. Use the external audio sequencer to record the performance 1. Connect external audio sequencer or PC via MIDI OUT or USB. 2. Set the equipment of channel 10 in the audio sequencer or in the sequence software, and than start recording. 3. Play the pads. 4.
DRUM KIT LIST VOICE LIST www.PyleUSA.
www.PyleUSA.
PERCUSSION LIST GM Percussion List Note No. Standard name Voice No.
57－A3 Crash Cymbal 2 57 LTCRSH1 58－A#3 Vibraslap 77 VSLP03 59－B3 Ride Cymbal 2 62 RIDE1 60－C4 Hi Bongo 78 HIBNGO01 61－C#4 Low Bongo 79 LOBNGO 62－D4 Mute Hi Conga 80 MHCNGA 63－D#4 Open Hi Conga 81 OHCNGA01 64－E4 Low Conga 82 LOCNGA01 65－F4 High Timbale 83 HTMBL1 66－F#4 Low Timbale 84 L0TMBL1 67－G4 High Agogo 85 HAGOGO1 68－G#4 Low Agogo 86 LAGOGO1 69－A4 Cabasa 87 CABASA1 70－A#4 Maracas 88 MRCAS1 71－B4 Short Whistle 89 SWHSL1 72－C5 Long Whistle
FEATURES: • Hassle-Free Tabletop Drum Kit • Compact, Portable & Ultra-Thin • Unique Roll-Up Design for Instant Drumming • Pre-Loaded with Selectable Drum Kits & Songs • MIDI Support: Connect to Computer & Unlock More • Record Mode: Playback Your Drum Sessions • Hand Percussion Mode: Drop the Drumsticks & Use Your Hands • Effectively Reproduces Complete 'Drum Set' Sounds • (7) Drum Pads with Touch Sensitivity • Tom-Toms, Hi-Hat, Snare & Bass Drums, Crash & Ride Cymbals • Super Easy & Simple USB Plug-in Opera
Questions? Comments? We are here to help! Phone: (1) 718-535-1800 Email: support@pyleusa.
