User Manual

DC 9V
AUDIO IN AUDIO OUT HIGH MID LOW
TONE
DC 9V
AUDIO IN AUDIO OUT LOW MID HIGH
Battery Cover
TONE
ON/OFF
Built-in short-circuit
protection circuit
www.PyleUSA.com
www.PyleUSA.com
Charging your TV speaker before rst use
Place the RECEIVER on the TRANSMITTER and charge for 2~3 hours
until the charging indicator of the RECEIVER is OFF which means the
battery is full.
Connect the power adaptor to the RECEIVER to charge the battery.
Low Battery and Recharging:
The red and green LED blink alternately and an alert sound occurs when
the receiver is in wireless state, or the red LED blinks when the receiver
is in the wired state. The battery power is lower at this moment.
Recharge the battery until full.
Operation
After connecting the TRANSMITTER to your TV, or other audio device:
1. Turn ON your TV, or other audio device, and set the volume properly.
Then switch ON the TRANSMITTER.
2. Turn ON the RECEIVER, and set the volume and tone
(HIGH/MID/LOW) to your required level.
3. After using, turn OFF the RECEIVER and switch OFF the
TRANSMITTER.
CHARGING
INDICATOR
RECEIVER
TRANSMITTER
AUDIO IN AUDIO OUT
LOW MID HIGH
Battery Cover
TONE
DC 9V
Power
Adaptor
CHARGING
INDICATOR
NI
OID
UA
DC 9V
OPTICA L
OFF ON
4 5