PWPBT60 Bluetooth Portable speakers User Manual www.pyleaudio.
TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS .............................................................................. 2 BEFORE USE .................................................................................................................. 4 COPYRIGHT .................................................................................................................. 4 BLUETOOTH CONNECTIVITY ..........................................................................................
9. Install the apparatus in accordance with the manufacturer’s instructions. 10. Clean the cabinet with a soft cloth slightly moistened with a mild detergent solution. Do not use strong solvents which may cause unpredictable damage to the apparatus. 11. Do not use attachments/accessories not recommended by the product manufacturer as they may be hazardous. 12. Power‐supply cords should be routed so that they are not likely to be trapped in any way.
product in defective states. BEFORE USE 1. Choose unit installation location carefully. Avoid placing it in direct sunlight or close to a source of heat. Also avoid locations subject to vibrations and excessive dust, cold or moisture. Keep away from sources that hum, such as transformers or motors. 2. Do not open the cabinet as this might result in damage to the circuitry or electrical shock. If a foreign object should get into the set, contact your dealer. 3.
meters. 3. Wait for a while then find the “E‐9150” on the paired devices list on your external device and press “E‐9150”. If sometimes A window will ask you a password. Fill in “0000” then press “OK” on your external device. 6. A few seconds later your Bluetooth connection is success. And you can hear “dodo”. ENJOY MUSIC FROM AN EXTERNAL DEVICE 1. It will play automatically and the light will stop flashing if you get your external device paired. (See “Getting connected”); 2.
Warning Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
SPECIFICATIONS AMPLIFIER Frequency Response SPEAKER SYSTEM Type Impedance …………. 60 to 20,000 Hz …………. …………. 1‐way 4 Ohm GENERAL Power Requirements …………. Dimensions (W x H x D) …………. USB Charge Standard Accessories …………. …………. The built‐in lithium battery voltage 3.7V Lithium battery capacity:1400mA 65 x 70x 201 mm(approx.) Without hand buckle 65x70x216 mm(approx.
