User Manual

ManualsBrandsPyle ManualsCurrency Handling2-in-1 Bill Counter & Counterfeit Bill Detector

Table Of Contents

Bill Exit

Power On/Off Switch

AC Power Input

USB Software

Upgrade Input

4 Digit LED Display

Red / Fail

Green / Pass

Bill Entrance/Exit

Status Indicators

Function Button

Introduction:

Counterfeit Bill Detector

Operating Instructions:

Starting up

Plug the power cord into the AC power input and plug the AC adapter into any

standard AC 110 volt or 220 volt outlet. Switch the machine onto the ON position.

The machine will then go though a calibration setup.

• The unit will display (8.8.8.8.).

• The unit will then sound two (2) beeps and a

Window.

• The machine will then verify the default currancy.

(EUr) Euro will show in the LED display.

• (UUUU) or ( ) will then be displayed.

This indicates the direction the bill will exit

after it is scanned. (See Function Button)

• The motor will then cycle twice.

• Once a (0) is displayed in the LED, the unit

is now ready use.

Getting Started

Once the (0) is displayed in the LED, the machine is ready to use.

• Place a bill along the left edge of the entrance

with the top of the head on the bill to the right.

• Gently push the bill into the entrance throat.

• The machine will pull the bill into the unit. It will

scan the bill for (IM) correct direction of bill

being fed (IR) Infrared characteristics, (UV)

Ultraviolet characteristics and (MG) Magnetic

strip detection.

• The machine will discharge the bill either through

the front of rear of the unit.

If The Banknote Passes Inspection

• If the bill passes inspection, the light in the

• The unit will sound a beep.

• The denomiation of the bill will be displayed

by the LED.

If The Banknote Fails Inspection

• If the bill fails inspection, the light in the

• The Unit will sound with (3) beeps.

• The LED will display the same amount

before the last bill was inserted.

• Failure Lights will display for feature or

Ready to Use

Place Bill Along Left Edge

Passes with GREEN Light

and Bill Denomination Displayed

Failed with RED Light

Failure LED Indicators Light

UUUU

Calibration Display

features which did not pass.(Status Indicator)