User Manual

10
PREPARATION
Installation
Installation Precautions
-
-
。
-
-
41
MAKING CONNECTIONS
HDMI
AUDIO OUT
RGB OUT(PC)
Accessories
Opitional Extras
Connecting to an HD
Receiver, DVD, or VCR Player
Connect an HD receiver, DVD, or VCR
player to the projector and select an
appropriate input mode
.
HDMI Connection
With an HDMI cable, you can enjoy high
quality picture and sound. Press the
INPUT button on the remote control to
select HDMI.
Connecting to a PC
The projector supports Plug & Play.
A PC will automatically recognize the
projector and requires no driver to be
installed.
RGB Connection
Connect the PC output and the PC
video input port of the projector with the
RGB cable.
For audio signal, connect the PC and the
projector with an optional audio cable.
Place the projector in a well-ventilated
environment.
To prevent internal heat from building
up, install the projector in a wellventilated
place.
Do not place anything near the projector
as this may block its air vents.
If the air vents are blocked, the internal
temperature will increase.
-
Do not place the projector on a carpet
or rug. If a projector model has
its inlet vent on its bottom, do not
block the vent and use the projector
on a leveled solid surface.
Be sure to prevent foreign objects such as
paper debris from entering the projector.
Leave an adequate distance (30 cm
or more) around the projector.
Do not place the projector in a hot or
humid environment.
- Do not place the projector in a
hot, cold, or humid environment.
(See56Page regarding operating
temperature and humidity.)
Do not place the projector in a place
where it will easily attract dust.
- This may cause a fire.
Do not remove any covers except for
the lens cap. There is a high risk of
electric shock.
The projector is manufactured using
high-precision technology. You may,
however, see tiny black dots and/
or bright colored dots (red, blue or
green) that continuously appear on
the projector screen. This is a normal
result of the manufacturing process
and does not indicate a malfunction.
The remote control may not work
in an environment where a lamp
equipped with electronic ballasts or
a three-wavelength fluorescent lamp
is installed. Replace the lamp with an
internationally standardized lamp for
the remote control to work normally.
•
•
•
•
•
•