User Manual

www.PyleUSA.com
www.PyleUSA.com
4 5
Getting Connected
Amplier, Mixer and External Sound System Connections
Music and Vocals
The unit's LINE OUT (RCA) jacks can be used to connect to a second power amplier, an external sound
system or mixing device.
Note: The unit offers optimum performance when used as an amp for home sound systems and smaller
performance systems and speakers.
Use L/R RCA audio cables to connect to an amplier, mixer or other external sound system. Connect from
the L/R LINE OUTPUT on the unit to the L/R audio input on your amp, mixer or sound system. Digital Karaoke
Mixing Amplier with Key Control
Outputting Vocals Independently
You can output vocals independently from the unit into a mixer from the L/R RCA MIC Outputs. Connect the
L/R RCA cable from the MIC OUTPUT to an Audio Input on your mixer.
External Speaker Connection
You can directly connect to speakers using either MDP (banana plug) speaker cables or standard speaker
wires. Be sure to correctly match the polarities (+/-). Connect rated speakers no lower than 4-0hms to the
unit. Please do not try to connect more than one speaker per channel, as the load may exceed the ampliers
handling capacity, causing it to overload.
If using standard speaker wire, unscrew each plastic bind until you are able to see an interior hole for
speaker wire (this is easier to locate when viewing from a side angle). Slide the speaker wires into the slots
and tighten the plastic binds to tighten them in place. Be sure there is no insulation on the speaker wire
preventing conductivity.
Getting Connected
Mic(s) connection
Using a mic cable with a 1/4"end, connect the
mic to either of the Unit microphone inputs.
Eects Loop Connections
Source Music (Music from a DVD or CD
player)
By using the built-in Effects Loop you can add
effects such as a professional Digital Key
Controller
to the source player's music without
compromising the quality of the original
signal. To use the effects loop connect an RCA
cable from the unit's EFFECTS LOOP L or R OUT
jack to the effects unit input.
Then connect an RCA cable from the effects
unit output, into the unit's L or R IN jack.
Vocals
MIC INSERT jacks on the rear panel to loop the
vocals through effects unit.
NOTE: In order to do this you must have a 1/4"
Y adapter cable (not included) for each
microphone line.
Connect the single end of Y cable into the MIC
INSERT jack. Connect one side of the double
end into the input on the effects device and the
other end into the output of the effects device.
NOTE: There will be no sound if the Y cable is
plugged into the unit but the double ends are
not connected to the IN and OUT of the device.
Mic with Remote Key Control
Connect the Remote Key Control cable into the
KEY CONTROLLER jack on the rear panel of the
unit.
NOTE: If you are not using the
Effects Loop, Be sure the LOOP BARS
are re-connected. Without these,
there will be no sound.