User Guide

TIMETRAX™ SYNC 5300 BELL RINGER
Installation Instructions
5 INSTALLATION (Cont.) 888.479.7264
6
Insert RJ45 cable into the BCD port
located on the bottom of the 5300 case.
Insert other end RJ45 cable into BCD
port on the side or back of time clock.
The top light will turn green, signaling
connection (this can take up to 2 minutes).
Continue to step 8 on next page.
Note: The time clock must be powered
and have the time set. If the time is
not set, the indicator light will not
turn on.
4
5
5
4
INSTALLATION (Cont.)
If using 5300 Bell Ringer with a TimeTrax™
Elite Time Clock System or TimeTrax Sync™
RF Wireless Transmitter, insert the end of
the RJ45 cable into the BCD port located
on the bottom of the 5300 case.
Insert other end RJ45 cable into BCD port
on back of TimeTrax™ Elite Time Clock
System or AUX port on back or side of
TimeTrax Sync™ RF Wireless Transmitter.
7
6
7
POWER AUX GPS
ETHERNET
TimeTrax™ Elite Time Clock System
TimeTrax Sync™
RF Transmitter
Connect to
PC Ethernet port
7
To PC Ethernet port
To 5300
BCD ETHERNET