Specifications

27
Remote Operation
Be sure to turn on the power of the camera before
the power of the RM-BR300 Remote Control Unit.
Otherwise, the RM-BR300 cannot recognize the
connected camera.
Note
To illuminate the panel of the RM-BR300
Remote Control Unit
Press the PANEL LIGHT button.
Operating multiple cameras
To assign camera addresses automatically:
1 Make sure that the camera address selector on
the bottom of each camera is set to 0.
2 Turn on the power of all the connected cameras
and the RM-BR300 Remote Control Unit.
3 Hold down the RESET button and press the
POWER button on the RM-BR300. The RM-BR300
recognizes the connected cameras and assigns
them camera addresses, 1 to 7, automatically in
the connected order.
4 To confirm, press the POWER button on the
RM-BR300 and check that the CAMERA buttons
light.
To assign camera addresses manually
Set one of the camera addresses, 1 to 7, using the
camera address selectors on the bottom of each
camera.
Camera address selectors
Set the address of the camera. This is normally set
to 0. With this setting, addresses are assigned to
the cameras automatically in the connected order
by pressing the POWER button while holding down
the RESET button on the RM-BR300 Remote Control
Unit. You can assign the camera address, 1 to 7,
manually by setting these selectors as follows:
Switch 4 is not used.
Camera
0 1 2 3 4 5 6 7
address
Switch 1 OFF ON OFF ON OFF ON OFF ON
Switch 2 OFF OFF ON ON OFF OFF ON ON
Switch 3 OFF OFF OFF OFF ON ON ON ON
Pan/tilt/zoom operation
3
2
1
L/R DIRECTION
STD
REV
PAN-TILT RESET
POWER
1 Press the CAMERA button corresponding to the
camera you want to operate.
2 Operate the joystick to pan or tilt the camera.
While checking the picture on the screen, incline
the joystick in the desired direction.
The panning/tilting speed changes according
to the angle at which you incline the joystick.
Release the joystick to stop panning/tilting.
To return the camera to facing forwards
Press the button on top of the joystick for one or
two seconds.
If you accidentally move the camera with
your hand
Press the PAN/TILT RESET button to perform the
Pan/Tilt Reset action.
If the camera moves in a different direction
from that you intended
The camera is preset to face towards the right
whenever the joystick is inclined to the right. You
might wish to face the camera towards a direction
that is opposite to the direction you inclined the
joystick. For example, you may want to change the
direction of the camera while checking the picture
on the screen. In this case, press the POSITION 2
(REV) button while holding down the L/R
DIRECTION button. To reset the setting, press the
POSITION 1 (STD) button while holding down the
L/R DIRECTION button.
Press for 1 or 2 seconds.
To turn on/off the camera using the
RM-BR300 Remote Control Unit
While holding down the POWER button, press the
CAMERA button corresponding to the required
camera. When you turn the power off using the
RM-BR300 Remote Control Unit, the POWER lamp
turns off and the STANDBY lamp lights on the
camera.
STANDBY lights.