Installation manual

PCX 256 PROGRAMMING MANUAL
RINS868-6 Page: 53
Test Bell?
To Test the Bell press the key. All outputs
programmed as either Bell or Strobe will be
tested. “Testing Bell will be displayed” Press the
 key to stop the test. ‘Test Bell’ will be
displayed, press the  key.
Do Battery Load Test?
To perform a Battery Load Test, press the
key.
The Battery Load test will be started.
Once the Battery test has completed, press the
 key, ‘Do Battery Load Test’ will be displayed,
press the key.
Test PGMs?
To test the PGMs press the key.
Select the PGMs you would like to test (see page
38 for the PGM types) and press the key.
All outputs programmed as the type selected will
be active. Press the key. The outputs will
switch off. Repeat for other output types as
required. Press the key. ‘Test PGM’s’ will be
displayed. Press the key.
Test PHC Communications?
To test the PHC Communications press the
key. This test is necessary to gain
authorisation for connection to the network for
SMS communication.
‘Press Y if using PABX or N if not’ will be
displayed. Press the key if you are using a
PABX system or the key if not.
Press the key once it has completed. ‘Test
PHC Communications’ will be displayed, press
the key. You will be returned to the Engineer
Menu.
If the test has failed please see page 65.