Installation manual

PCX 256 PROGRAMMING MANUAL
Page: 54 RINS868-6
5.21 Diagnostics
The diagnostics on the PCX system allows you to view all parts of the system, including input
resistances, power supplies and current.
The diagnostic resolution is:
¾ Voltage: 0.1V
¾ Current: 0.01A
The diagnostics that can be viewed are:
¾ System voltage and current at the control panel and at each individual power supply.
¾ System voltage at each keypad / tag reader.
¾ Battery condition and charge current at control panel or any remote power supply.
¾ Display inputs – current state of all inputs connected to a single system component,
displayed in real time. In the “View Inputs” function
¾ Calibration – permits calibration if control panel PSU voltage, using a calibrated meter.
Visual Keypad Programming Procedure
DIAGNOSTICS
Diagnostics
Using the and keys, scroll to
‘DIAGNOSTICS’ Press the key
To view the diagnostics of the power supplies
press the key
The Endstation PSU statistics will be displayed.
Press the key.
Enter the address of the RIX you wish to view.
Repeat for each RIX. Press the key.
Repeat for the ROXs, Keypads and Readers you
have on the system.
Press the key.
To view the input diagnostics, press the key.
‘Endstation Inputs’ will be displayed. To view the
Endstation inputs only, press the key.