Installation manual

PCX 256 PROGRAMMING MANUAL
Page: 58 RINS868-6
5.23 Programme DIGI / SMS?
The PCX system can be used to dial to an Alarm Receiving Centre or send SMS texts to a mobile
phone.
5.23.1 Programming Fast Format
The Fast Format type 4.8.1 is selected as default for the digi. Up to four numbers can be
programmed, each with individual account numbers, channel information and back up telephone
number option. The channels can be individually programmed in the “Program Digi Channels”
section. Each channel uses a programmable output number. The default values are described on
below:
DIGI CHANNELS PGMs DIGI CHANNELS PGMs
Digi Channel 1 Fire (0001) Digi Channel 6 Confirmed Any (0006)
Digi Channel 2 HU Device Any (0009) Digi Channel 7 Omit Rearm Any (0017)
Digi Channel 3 Unconfirmed Any (0018) Digi Channel 8 AC Fail (0052)
Digi Channel 4 Final Arm Any (0022) Digi Channel 9 Global Fault 2 (0056)
Digi Channel 5 Tamper Any (0007) Digi Channel 10 Test ATS (0064)
The communicator “status channel” (channel 0) is used for low voltage and test calls.
5.23.2 Adding a Pause
For a 2 second pause after a telephone number digit, press the D key until you reach the
‘comma’ symbol (‘,’). This is usually used if a ‘9’ is needed before the telephone number.
Visual Keypad Programming Procedure
PROGRAMME DIGI/SMS
Fast Format 8 Channel
Programme Digi / SMS
Using the and keys, scroll to
‘PROGRAMME DIGI/SMS’ Press the key
To ‘Program Digi / SMS Calls’ will be displayed,
to program in an ARC number, press the key
Disable Digi/SMS
Enter : for No (Enables the Digi Modem)
Enter : for Yes (Default) Press the key.
Use the numeric keys to select the ARC details
to program. Press the key
Active
Enter : for No (Default)
Enter : for Yes (Enables the ARC Details)
Press the key