Installation manual

PCX 256 PROGRAMMING MANUAL
RINS868-6 Page: 61
17 SL SwitchOn *Switcher input active
18 SL SwitchOff *Switcher input
restored
19 SL OtherOn *Other input active
20 SL OtherOff *Other input restored
* - Signalled ONLY for inputs with ‘Special
Logged’ attribute.
21 Sub-partitions Set Arming events for sub-partitions
22 Sub-partitions Unset Disarming events for sub-partitions
23 Sub-partitions Alarm Alarm event in a sub-partition
24 Input Omitted Input omitted at rearm.
25 Input Restore Restore of type 05
26 Test Call Do not Use
27 Mains fail Mains fail/restore
28 Emergency input Fire, Gas, HU, 2-key HU, Duress Code used
29 Emergency Restore Restore of Fire, Gas, HU.
30 Tamper input Tamper, Day alarm, and Trouble input types. Tamper on input, case
tamper and SAB tamper.
31 First Tamper input First to alarm of tamper input.
32 Tamp Input Restore Restore of a tamper.
5.23.4 PABX Systems (Only relevant to SMS)
Please note for PABX telephone systems (where a “9” is needed in order to dial an outside line),
you must put “NN” before the account number in the “account reference” part of the programming
(see below). If you haven’t been given an account number then the account reference “NN1111”
would be OK to use. This needs to be entered on the keypad.